DSC PowerSeries Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol DSC PowerSeries. DSC PowerSeries 20 halaman. Telephone interface & automation control module
Juga untuk DSC PowerSeries: Lembar Ringkasan Produk (20 halaman)

DSC PowerSeries Panduan Pengguna
bypassed when arming your system. Zones cannot be bypassed once the system is armed. Bypassed
zones are automatically cancelled each time the system is disarmed and must be bypassed again, if
required, before the next arming.
Bypassing Zones
With the system disarmed.
1. Press
to enter the function menu. The keypad will display "Press
2. Press
or
Bypass Zones".
3. Enter the two-digit number of the zone(s) to be bypassed (01-34).
You can also use the
zone. The keypad will display "Zone Name". "B" will appear on the display to show that the zone is
bypassed. If a zone is open (e.g., door with door contact is open), the keypad will display "Zone Name
O". If you bypass the open zone, a "B" will replace the "O".
4. To unbypass a zone, enter the two-digit number of the zone(s) to be bypassed (01-34). You can
also use the
disappear from the display to show that the zone is no longer bypassed.
5. To exit bypassing mode and return to the Ready state, press
Activating All Bypassed Zones
To remove bypass (all zones):
1. Press
, then your [access code] (if necessary).
2. Press
.
3. To exit bypassing mode and return to the Ready state, press
Recalling Bypassed Zones
To recall the last set of bypassed zones:
1. Press
, then your [access code] (if necessary).
2. Press
.
3. To exit bypassing mode and return to the Ready state, press
Bypass Group
A Bypass Group is a selection of zones programmed into the system. If you bypass a group of zones
on a regular basis, you can program them into the Bypass Group, so that you do not have to bypass
each zone individually every time. Only one Bypass Group can be programmed.
NOTE: If a group has already been bypassed before programming a Bypass Group, you will be
unable to recall that group after programming the new group.
To program a Bypass Group:
1. Press
, then your [access code] (if necessary).
2. Enter the two-digit numbers (01-34) of the zones to be included in the Bypass Group or
use the
to select the zone.
3. To save the selected zone into the group, press
4. To exit bypassing mode and return to the Ready state, press
NOTE: If an access code is required to enter bypassing, only the Master Code and codes with
Supervisory enabled can set the Bypass Group.
, then your [access code] (if required). The keypad will display "Scroll to < >
keys to find the zone to be bypassed, and then press
keys to find the zone, and then press
keys to find the zone to be included in the bypass group, then press
to select the zone. The "B" will
.
5
for < > Zone Bypass".
to select the
.
.
.
.