Foxpro FIRE FLY Buku Petunjuk - Halaman 7
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pemindai Foxpro FIRE FLY. Foxpro FIRE FLY 8 halaman. Scan light
Halaman Cetak
Do not connect the charger to the light and an external battery at the same time!
Never attempt to charge batteries that are not intended to be recharged! This includes
both Zinc Carbon and alkaline cells. The resulting damage can be serious and will not be
covered by the warranty.
For maximum charge efficiency, we recommend charging the battery in temperatures
ranging from 40°F to 85°F (5°C to 30°C).
Make sure that the rechargeable battery pack is properly installed in the Fire Fly Scan Light.
Connect the approved FOXPRO charger to the charge jack on the Fire Fly Scan Light and
attach the transformer to the appropriate outlet.
Do not leave charging batteries unattended.
Remove the battery pack from the Fire Fly Scan Light when it will not be used for prolonged
periods.
Recharge your battery pack periodically.
Using the Fire Fly Scan Light
This section covers standalone Fire Fly Scan Light operation in detail. Please read the following warning
prior to use:
DO NOT LOOK DIRECTLY INTO THE LIGHT WHEN IT IS POWERED ON AND NEVER SHINE THE LIGHT
DIRECTLY INTO THE EYES OF ANOTHER PERSON! THE FIRE FLY SCAN LIGHT IS EXTREMELY BRIGHT
AND IMPROPER USE COULD RESULT IN PERMANENT EYE DAMAGE! THE LIGHT SHOULD ALWAYS BE
FACING DOWN RANGE AND AWAY FROM OTHER PEOPLE.
3-1 Turning on/off the Fire Fly Scan Light
Turn on the Fire Fly Scan Light by pushing the Primary Trigger Button a single time; the light will turn on
immediately. To turn off the Fire Fly Scan Light, push the Primary Trigger button again.
3-2 Setting the Brightness
On the rear of the Fire Fly Scan Light you will find the Brightness Adjustment Slider. The brightness ranges
from lowest (slider completely to the left) to highest (slider completely to the right). By moving the slider
from left to right you can control the brightness. The higher you set the brightness, the more power will be
required to operate the light at the brightness level. See Section 1-4 of the manual for run times. If you have
the slider set to a low brightness setting, you can push the Instant Max Bright Button, located under the
Primary Trigger Button. The Fire Fly will be at its maximum brightness level for the duration that you hold in
the Instant Max Bright Button and returns to the brightness set by the slider upon release.
3-3 Adjusting Beam Focus
The Fire Fly Scan Light beam can be adjusted to produce a wider (less focused) or narrower (more focused)
beam by twisting the beam adjustment either clockwise or counterclockwise. With the beam adjustment
twisted fully counterclockwise, the beam will be at its narrowest or most focused state. With the beam
adjuster moved fully clockwise, the beam will be at its widest or least focused state.
3-4 Low Battery Detection & Checking Battery Level
While operating the Fire Fly Scan Light, if the battery pack gets low, the LED will blink two times every 3
seconds to indicate the low battery state. This indicates that it is time to recharge your battery pack or
install a fresh one. For charging information, please refer to Section 2 of this manual. You can check the
battery level when the Fire Fly is turned on by pushing the Battery Level Test button, located above the LED
WARNINGS AND GENERAL PRECAUTIONS FOR CHARGING
WARNING!
7