AirTime ATDDC4 Instalasi & Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Instalasi & Panduan Pengguna untuk Jam AirTime ATDDC4. AirTime ATDDC4 8 halaman. Wireless digital wall clock

Halaman Cetak

THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS

PURSUANT SUBPART J OF PART-15

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this product not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

NOTE: This equipment has been tested and found to comply with the limits for a digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm between

the radiator and your body. This Transceiver must not be co-located or operating in conjunction with

any other antenna or Transceiver.

Disclaimer

The information within this document has been carefully checked and is believed to

be entirely reliable. However, no responsibility is assumed for inaccuracies. Lathem

Time Corp. reserves the right to make changes to any products herein to improve

reliability, function, or design.

Trademark

AirTime, Lathem and the Lathem logo are registered trademarks of Lathem Time

Corporation. Other product names mentioned in this manual may be trademarks of their

respective companies and are hereby acknowledged.

WARNING: Changes or modifications to this product not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

200 Selig Drive SW

Atlanta, GA 30336

www.lathem.com

Lathem Inc

Other AirTime Products

ATX

Mini Transceiver capable of

receiving the WWVB signal and

transmitting exact time in smaller

facilities

AT12RPS

Solar Powered 12" Analog

Wireless Wall Clock

AT-ANTOD

Outdoor Antenna for maximum

coverage with the ATX6 or the AT20WT

AT-MSX

AirTime receiver that accepts the AirTime signals from

an ATX, ATX6 or AT20WT and

corrects Lathem RS485

devices or Intercom systems

via a 12:00AM dry contact

closure

Contact your distributer or visit

www.lathem.com

for more information