DSPPA MAG6835 Petunjuk Manual - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Penguat DSPPA MAG6835. DSPPA MAG6835 6 halaman. 1u ip network amplifier
Juga untuk DSPPA MAG6835: Manual (5 halaman)
Halaman Cetak
Front / Rear Panel
1
1 Mounting Holes
2 Power Switch
3 Signal LED
Power: Power LED. It will be on when
powered on and turned on.
Net Service: Net LED. It will be on when the
machine
successfully.
Timing: Timing point LED. The amplifier can
execute the edited timing points on the
host when separated from the host. The
LED will be on when the terminal is able to
perform the timing points without the
host.
Signal: Amplifier output level LED. It will be
on when the amplifier has signal output,
and it will turn brighter when the volume
increases and darker when the volume
decreases.
CILP: CLIP LED. It will be on when the
output signal is too large.
PROT: Protection LED. It will be on when
there is over current, over heat or short
circuit in the amplifier.
4 Digital Display Screen and IR Remote Receiving
Window
The digital display screen shows the working
status of the machine and the status of network
information. The infrared remote receiving
window is embedded in the lower left corner of
the display screen, and it can bring the machine
under control with the infrared remote
controller.
5 "USB" Button
USB Play/Stop Button; press the button to
/
www.dsppatech.com
电源
2
is
connected
to
the
Power
Net Service
Timing
Signal
CLIP
Public Address Network Amplifier
PROT
3
exit the setting status when setting the IP.
6 "F1" Button
Used to switch among AUX IN, MIC IN and
MP3 when adjusting the volume.
7 "Set" Button
Set button. Long press the button to enter
the IP checking status, and press again to
host
enter the IP setting status.
8 "VOL-" Button
Used to turn down the volume in the play
mode; used to switch parameters selected
for checking in the IP checking mode; used
to add or subtract parameters in the IP
setting mode.
9 "VOL+" Button
Used to turn up the volume in the play
mode; used to switch parameters selected
for checking in the IP checking mode; used
to add or subtract parameters in the IP
setting mode.
Button
10
Used to select the next song program in
the play mode; used to move right one
screen/right one bit, and select parameters
for checking/setting in the IP setting mode.
Button
11
Used to select the previous song program
in the play mode; used to move left one
screen/left one bit, and select parameters
for checking/setting in the IP setting mode.
Button
12
Play/Pause button. It is used to play /
pause the program when playing local MP3
programs; used to save the setting result
when setting the IP.
The specifications will be subject to change without prior notice.
Copyright © Guangzhou DSPPA Audio Co.,Ltd All rights reserved.
12 11 10 9
MAG6806
VOL+
USB
F1
Set
VOL-
4
5 6 7 8