DSW DSW01 Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk untuk Sistem Keamanan DSW DSW01. DSW DSW01 5 halaman.

3. Attention:

3.1 Low-battery indicate: when the battery energy is below 7V, the low-battery LED in crystal board will flash

once a second and you should replace the battery;

3.2 Avoid installing the unit on metal base;

3.3 Avoid installing the unit where sun shine or temperature change obviously, for example: air conditioning,

heater etc.

DOOR MAGNETISM

1. install magnetism and emitter on upright position of door lock, the

distance between them is 3mm~5mm and triangle on emitter aim at

triangle on magnetism(like right figure);

2. install DC12V battery into emitter;

3. press fortify key on 4-key remote controller, set general controller on

fortify state;

Open door, the emitter is triggered and its LED light, then emit signal

to general controller, the general controller alarm, provided that its

corresponding channel is channel 5, the Ch5 should light.

Tamper design: Under the condition that the triangle on emitter aim at triangle on magnetism, when emitter's

battery lid is removed, it will emit signal and its LED light.

Attention: the magnetism should be on the left of the emitter(like following figure).

THE SYSTEM CONFIGURATION

Basic

configuration

General controller*1

Wire detector:

The units for your

choosing at will

C o rre ct p o sitio n

doorbell remote controller*1

TK-5

glass-break detector

Incorre ct positio n

4-key remote controller*1

695

DDT-15 glass-break&

PIR detector

D O O R

D O O R F R A M E

D O O R L O C K

DPS-55 PIR detector*1

door magnetism*1

double detector