DT Research DT315BT Panduan Pengoperasian Dasar - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengoperasian Dasar untuk Tablet DT Research DT315BT. DT Research DT315BT 4 halaman. Mobile tablet
Halaman Cetak
DT315BT/ DT315BT-MD
OPERATION
Internal Battery
!
Warning!
The Internal battery pack should only be replaced by an authorized DT Research service
representative. Please contact your product and/or service provider for internal battery
replacement service.
Powering ON and OFF
To activate the DT315BT/ DT315BT-MD, push and quickly release the Power Button. The
display will come on in a few seconds. To put the DT315BT/ DT315BT-MD in Standby
mode, push and quickly release the Power Button. To turn the DT315BT/ DT315BT-MD
off for extended storage, power off safely using any software function that "shuts down
computer" provided in the software operating system.
NOTE:
The battery packs shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT315BT/ DT315BT-MD when setting up for the first
time to fully charge the internal battery pack. You may charge the external battery
pack with it attached to the DT315BT/ DT315BT-MD, or with the optional external
battery charger kit.
NOTE:
When the battery pack(s) is (are) charging, the blue-colored Battery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
activity and the LED stays dark, the battery pack(s) may have been drained
substantially. Try unplugging/ replugging the AC-DC adapter to the DT315BT/
DT315BT-MD a few times to activate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Button to put the
tablet in "Standby" mode while not in use. Pushing briefly on the same button
will wake up the system within seconds.
NOTE:
Avoid using the Power Button ("hold 4+ seconds" feature) to turn off the
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operation.
4
ENGLISH
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed after a launch sequence of several seconds. The wireless LAN
connection may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT315BT/ DT315BT-MD may be configured using the utilities and methods dictated
by the software operating system. The DT315BT/ DT315BT-MD should be configurable
for various properties such as user profiles, network features, and several system
elements.
Wireless Networking
Wireless LAN
The DT315BT/ DT315BT-MD is often delivered with an embedded (user-inaccessible)
802.11ac WLAN adapter equipped with a hidden custom antenna.
•
Through the support of typical WLAN adapters, the DT315BT/ DT315BT-MD should
be able to detect all 802.11 access points in the vicinity for you to select the access
point of your choice for connection.
•
The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT315BT/ DT315BT-
MD and the access points have to match. The SSID is case-sensitive and it is recom-
mended that you enable WEP/WPA/WPA2 encryption (or advanced alternatives)
for secure access.
•
When WEP/WPA/WPA2 is enabled, you may need to consult your network admin-
istrator or your networking equipment literature to properly configure associated
settings such as Authentication mode, etc.
•
Refer to the access point operating manuals for setting up the 802.11 access points
.
5
ENGLISH