DT SWISS RATCHET EXP Panduan Teknis - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Aksesori Sepeda DT SWISS RATCHET EXP. DT SWISS RATCHET EXP 20 halaman.
Juga untuk DT SWISS RATCHET EXP: Panduan Pemeliharaan (13 halaman)

Halaman Cetak

2.10 PRESSING THE BEARING INTO THE THREADED RATCHET

1. Slightly grease the contact surface of the

bearing and the threaded ratchet.

2. Put the threaded ratchet with the toothing

facing downwards onto the mounting /

dismounting tool.

→ Put the ratchet on the side of the tool

with the fitting diameter. The ratchet

may only move minimally in tool.

3. Put a new bearing with the colored side

facing downwards onto the ratchet.

4. Carefully press the bearing into the ratchet with light hammer strokes on the outer ring of the

ball bearing until the bearing protrudes 1 to 2 mm beyond the ratchet.

→ The bearing must not be pressed further into the ratchet.

2.11 SCREWING THE THREADED RATCHET WITH THE BEARING INTO THE HUB SHELL

1. Slightly grease the threaded ratchet and

the thread of the hub shell with universal

grease.

2. Clamp the mounting / dismounting tool for

the threaded ratchet into the vice.

3. Put the threaded ratchet with the bearing

onto the mounting / dismounting tool.

→ The toothing of the threaded ratchet

must face downwards.

4. Slide the axle with its long end through the

bearing.

5. Put the hub or the wheel onto the mounting

/ dismounting tool.

HXTXXX00N8387S

Ratchet EXP - Technical Manual

HXTXXX00N6106S

1-2 mm