Bounce LED NOVANEON Reflex V1620 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Lampu luar ruangan Bounce LED NOVANEON Reflex V1620. Bounce LED NOVANEON Reflex V1620 5 halaman. Led strip light

Halaman Cetak
Installation Guide
WARNING Please read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing or installing product
1
Cut material to length required using Novaneon Shears (cut only
at intervals marked on the side of the casing).
3
Choose Left or Right Side Connect and Insert Contact Strip.
Insert Contact strip into cut end of Novaneon. Where the PCB is
on the left side of the strip, use a left connector, where it is on
the right side, use a right connector.
5
Install End Caps
Apply silicone glue to cut end of strip, and slide end cap over.
Clean up excess silicone with a clean cloth. Silicone will cure in 4
hours.
SALES & SUPPORT
02 9517 3222 |
PH
E
www.bounceled.com.au
2
Install clear PC terminals to both ends of Novaneon to prevent
glue leaking to LED units.
4
Slide Cover Over to Seal
Apply silicone glue to cut end of strip, and slide cover over. Next,
apply silicone over the end of the cap and push metal ring over.
Clean excess silicone with a clean cloth. Silicone will cure in 4 hours.
6
Novaneon strip can be mounted using Aluminium Track or clear
clips. When handling strip, take care to only bend horizontally and
do not twist/stretch strip as this may damage internal components.