dtec DYNertia3 Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Alat Ukur dtec DYNertia3. dtec DYNertia3 20 halaman.

DYNertia3 Quick Start (Inertia- Chassis type)

Basic Hardware Settings

As an example of a basic test 'Run' we will test a motorbike, we will do the test in 4

reference.

This example Dyno has roller of 1000mm circumference and an inertia factor of 4.7 kg/m² (your dyno's inertia value can

be calculated by pressing the 'MOI" button in Setup/Hardware and adjusted later if required). DYNertia sensor is picking

dyno RPM up from the roller. Leave program settings are in their default position.

At the top Left of the Window you will find the menu options. Under the menu option "Setup" you will find "Hardware".

Roller Circumference: Enter roller circumference (1000mm in this example) to ensure speeds displayed (kph/mph) are

correct

Inertia Mass: Enter the dyno's MOI (Moment Of Inertia) inertial value, 4.7 for this example.

As mentioned above, your dyno's inertia value can be calculated by pressing the 'MOI" button at the top of the window.

Leave other settings in their default position as shown, especially DO NOT choose any alternative RPM source.

Ensure 'INERTIA' mode is selected.

Select 'CHASSIS' dyno type.

www.dtec.net.au

gear and save the results for future