Attwood 5091 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Perahu Attwood 5091. Attwood 5091 2 halaman. 12-volt 1-mile bi-color pole lights

Halaman Cetak

12-Volt 1-Mile

Bi-Color Pole Lights

5091, 5092

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and

other marine accessories are specified more than any other brand by

America's best-known boat manufacturers as original equipment.

Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69381 Rev. B

FEATURES

The new Attwood 12-Volt, 1-Mile Navigation Sidelights for boats

up to 39.6 ft. (12 meters). They feature impact resistant, UV-stable

polycarbonate housings. The lens completely encapsulates the bulb

and socket assembly for a splash resistant seal. Meets USCG CFR

183.810, ABYC A-16 requirements, and all applicable standards as

tested by Imanna Labs, 3/31/1997. 1 Nautical Mile visibility. Uses

Lamp 9235, #906 13V, 6 Candle Power.

REQUIRED FOR INSTALLATION

• Cordless drill with 1/8" (3mm), 3/8" (10mm) and 3/4" (19mm) bits.

• Screwdriver.

• Two #8 or #10 stainless pan head screws per light.

• Non-silicone sealant.

WARNING:

To prevent personal injury, always disconnect the power source

when installing or servicing this product. Always remove the boat

from the water before using 120V AC power tools.

LOCATION

Lights must be mounted so that the light pattern is unobstructed.

Locate Bi-Color combination light in an area as far forward as

possible. (Figure 1)

Figure 1

Red

Green

(Port)

(Starboard)

INSTALLATION

Pole Light

CAUTION:

All positive (+12V DC) wires must be fused to protect your circuits

and vessel. The Universal Fit Light requires a 1-amp fuse. The

03-10

aluminum pole of the Universal Fit Light is not connected to an

electrical ground.

Replacing a Light Without a Locking Collar

1. Insert pole into base, aligning screws with slot in base.

2. Press down firmly to engage electrical connectors.

3. Lock pole in position with lock mechanism of base.

4. To remove light, unlock pole from base and pull straight up.

(Figure 2)

Figure 2

Replacing a Light With a Locking Collar

1. Remove both screws from base end of pole.

2. Slide plastic locking collar supplied with Universal Fit Light up over

terminal connector and past screw holes on pole.

3. Replace screw closest to base end of pole only.

4. Insert pole into base, aligning screw with slot in base.

5. Press down firmly to engage electrical connectors.

6. Slide locking collar down to base, rotate until lower ring can be

inserted inside top of base.

7. Press down into base and rotate until locking collar tightens

between pole and base.

NOTE:

Periodically check pole to make sure it is secure.

8. To remove light, rotate locking collar in opposite direction until it

loosens, then pull up on pole. (Figure 3)

After installation, activate lights to verify proper operation. Navigation

light regulations require lights to be operated with a three-position

switch that provides for:

• Running lights (sidelights and all-round light).

• Anchor lights (all-round light only).

• Off.