DTM System PIKO 150 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penerima DTM System PIKO 150. DTM System PIKO 150 17 halaman. 1-channel
Halaman Cetak
GENERAL INFORMATION
The series of 1-channel PIKO receivers are designed for cooperation with gate controllers, roller shutters and other automation
devices, where the remote control is required. It allows to easily extend the functionality of the installation with the remote
control function.
TECHNICAL DATA
MEMORY
FREQUENCY
POWER CONSUMPTION
POWER SUPPLY
OUTPUT
OUTPUT LOAD
OPERATION MODE
TEMPERATURE
INGRESS PROTECTION
DIMENSIONS
AVAILABLE FUNCTIONS
EASY REMOTE ADDING
EASY REMOTE ADDING LOCK
GALACTIC FUNCTION
VERIFYING NUMBER OF REMOTES
1. Installing the receiver
The receiver is intended for use inside
installation boxes, inside buildings and inside
enclosures of other automation devices, while
ensuring appropriate operating conditions,
consistent with the device parameters. Do not
install the receiver in places subject to high
humidity or frequent and sudden changes in
temperature.
Othe receiver has a cable harness with four wires
(fig.1) for connecting the receiver's power supply
- red and blue, and for connecting a controlled
device - white and black. The receiver is factory
equipped with a wire antenna.
The housing has a hole for a clamp for
convenient mounting of the receiver.
Pay attention to the colors of the
w i r e s a n d c o n n e c t t h e m a s
intended!
15 remotes
15 remotes
150 remotes
DTM433MHz
DTM433MHz
+ other
producers
433MHz
30mA
12...24V AC/DC ±10%
one, separated NO type
1A/24V AC/DC
monostable, turn-on time 1s
-20°C /+55°C
41x30x19 mm
only DTM433MHz
antenna
Fig. 1. View of the receiver
with pin description.
150 remotes
200 remotes
DTM433MHz
DTM433MHz
DTM868MHz
+ other
producers
IP-20
only DTM433MHz
cable
harness
868MHz
40mA
EN
C1 LED
C1 programming
button
+~ _
C
NO
12-24V