Atwood CA Panduan Pemasangan, Pengoperasian, dan Pemeliharaan - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pemasangan, Pengoperasian, dan Pemeliharaan untuk Rentang Atwood CA. Atwood CA 16 halaman. Lp gas range & slide-in cooktops
Juga untuk Atwood CA: Panduan Pemasangan & Pengoperasian (8 halaman), Pengoperasian & Pemeliharaan Instalasi (10 halaman), Pengoperasian & Pemeliharaan Instalasi (8 halaman), Petunjuk Pemasangan, Pengoperasian, dan Pemeliharaan (8 halaman)
Halaman Cetak
3. Cabinet dimensions needed for each model are shown in CABINET &
COUNTER CUT OUT CHART. The cabinet cut-out must be located
with respect to the minimum clearances to combustible materials as
noted. When planning the location, consider curtains or other
combustible materials installed around the range or cooktop.
Note: For models having suf x "N" (i.e. RV1735 BGPN) Countertops with
an overhang must be notched as shown in the illustrations. The notch
should be 7/16˝ minimum, both sides.
FIRE AND/OR EXPLOSION
•
- Gas supply pipe must be installed with
KNIFE RACK INSTALLATION
clearance from knives contacting or cutting gas lines.
4. When the cabinet has been prepared according to the dimensions
given and the gas line is in place, remove the range or cooktop
from its packaging and position the range or cooktop in the opening.
5. Verify the range or cooktop is level from side to side and front to rear.
6. Remove the cooking grate(s), slide the range top back about 1/8", then
lift up on one of the front corners (
7. Fasten the range or cooktop in place with wood screws (not supplied)
through holes in burner box. Care should be taken to not force the
range mounting
s to bend, which may cause the range or
cooktop to be mounted too low in the cabinet cutout.
• Gas line material inside the burner box must be rated for a
minimum of 300°F operation.
8. Make the gas connection. All openings in the cabinetry around the
gas line must be closed at time of installation. With electronic ignition:
Complete the electrical connections as shown in the WIRING
DIAGRAM. For galley slide-out applications, it is highly recommended
that the negative 12 volt connection be connected directly to the
battery. Voltage supply must be between 9 and 13VDC. Appliance
electrical rating is 12VDC, 0.6A during sparking.
PRODUCT DAMAGE HAZARD
• Connect to 12VDC service only.
•
connect to a circuit fused for more than 3 amps.
DO NOT
•
hi-pot range unless electronic ignition system has been
DO NOT
disconnected.
9. Turn on the gas supply.
EXPLOSION OR FIRE
•
use matches, candles or other sources of ignition to test
DO NOT
ings and gas lines for leaks.
10. Check all connections for gas leaks using a non-corrosive leak detection
uid. Do not use a soap and water solution. Leak test in excess of 8
oz. per square inch (1/2 psi) of air pressure will invalidate warranty.
11. Replace range top (
4-5). Range/cooktop is now ready for operation.
FIG
TOP BURNER OPERATION
BURN INJURY, FIRE AND/OR EXPLOSION
• Use range or cooktop only for use as described in this manual.
•
leave children alone or unattended in area where range or
DO NOT
cooktop is in use. Never allow anyone to sit, stand, or climb on any part
of the range cooktop. They could be burned or injured.
•
store things children might want above the range or cooktop.
DO NOT
Children could be burned or injured while climbing on it.
•
wear loose or hanging garments when using the range or cooktop.
DO NOT
They could ignite if they touch an open
• Use only dry potholders. Moist or damp potholders on hot surfaces may
result in burns from steam. Do not let the potholder touch an open
use a towel or bulky cloth for a potholder. It could catch on re.
DO NOT
•
heat unopened containers. They could explode. The hot contents
DO NOT
may cause burns and container particles may cause injury.
•
use range or cooktop for warming or heating vehicle. You could
DO NOT
be burned or injured, a re could start, or deplete oxygen in the vehicle.
•
store
mmable materials on, in, or near the range or cooktop.
DO NOT
Any fumes can create an explosion and/or re hazard.
WAR NING
3) to remove the range top.
FIG
WAR NING
FIRE
CAUT ION
WAR NING
WAR NING
me and you could be burned.
BURN INJURY, FIRE AND/OR EXPLOSION
• All control knobs must be turned to OFF when not in use. Fire and/or
burning hazard may occur if a burner is accidentally left ON.
•
operate range or cooktop if it is damaged or not working properly.
DO NOT
• Know where your vehicle's main LP gas shutoff is located.
• Verify suf
t gas supply before attempting to light any top burner. Air in
the gas supply line will
light unexpectedly as the air in the line clears out and is replaced by LP
gas; this unexpected ignition may burn you. Air may be introduced into the
supply line when the vehicle gas bottle is replaced, during servicing of other
gas appliances, etc.
• If any burner should extinguish (after initially lighting or due to accidental
blow-out), turn all burner knobs clockwise
MINUTES before again attempting to light the burner.
•
touch top burners, burner grates, or other areas near top burners
DO NOT
during and after use. Do not let clothing or other
contact top burners or areas near top burners until they have had suf
time to cool.
• Make sure the utensils you use are large enough to contain food and avoid
boil overs and spillovers. Heavy splattering or spillovers left on the cooktop
can ignite and burn you.
•
drop pans on the porcelain surface. Cracks or chips in the
DO NOT
porcelain surface may result.
• Be sure that glass cooking utensils are safe for use on the cooktop. Only
certain kinds of glass utensils are suitable for surface or top burner use
without breaking due to the sudden changes in temperature.
• Never leave top burners unattended. A boil over could result and cause
smoking and greasy spillovers that may ignite.
• Turn pan handles inward, but not over other top burners. This reduces the
chance of burns due to bumping pan.
• Grease is
. Never allow grease to collect around top burners or
on cooktop surface. Wipe spillovers immediately.
•
use water on grease res. Never pick up a
DO NOT
ng pan with a
the pan can be extinguished with baking soda or a multipurpose dry
chemical or foam-type re extinguisher.
• Use care when lighting a top burner by hand. If the burner lights
unexpectedly, or your hand is close to the burner, you may be burned.
• Burner ame should not extend beyond the edge of the cooking utensil.
The
me could burn you and cause poor cooking results.
1. Check that gas is on at shutoff valve.
2. LIGHTING Top Burners:
a. All burner controls operate counter-clockwise
pressed inward (toward the cooktop) to turn ON or LITE. Do not
attempt to light more than one burner at a time.
b. IMMEDIATELY light the burner by holding a lit match or a hand-held
spark igniter designed for this purpose near the burner ports.
c. To extinguish the top burner
clockwise
to OFF.
LIGHTING Top Burners with spark ignition: (
a. Turn the appropriate burner knob counter-clockwise
Do not attempt to light more than one burner at a time.
b. Turn the SPARK knob clockwise
light, continue turning the SPARK knob clockwise
lights.
c. To extinguish the top burner
clockwise
to OFF.
LIGHTING Top Burners with electronic ignition:
a. Turn the appropriate burner knob counterclockwise
This will automatically activate the ignition system, and all burners will
begin to spark repeatedly. This is the "clicking" sound you will hear.
b. The burner will light within
the knob counterclockwise
c. To extinguish the top burner
clockwise
to OFF.
me.
d. If 12 VDC power is not available to the ignition module for any reason,
top burners may be lit manually. See instructions in "Lighting Top Burners".
PRODUCT DAMAGE HAZARD
•
cook with the control knob set in the LITE position.
DO NOT
Damage to the ignition module and burner electrodes may result.
2
WAR NING
y delay burner ignition, and a burner may
to OFF and WAIT FIVE (5)
mmable materials to
ng pan. Smother a
g lid or cookie sheet. Flaming grease outside of
and must be
e, turn the appropriate burner knob
4-5)
FIG
to ON or LITE.
one "click". If the burner fails to
until the burner
me, turn the appropriate burner knob
to ON or LITE.
e (5) seconds. Once the burner is lit, turn
to the desired setting.
, turn the appropriate burner knob
CAUT ION
nt