Atwood 493433 Pengoperasian & Pemeliharaan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Pengoperasian & Pemeliharaan Instalasi untuk Aksesori Mobil Atwood 493433. Atwood 493433 7 halaman. Bike rack for recreational vehicle ladder

Halaman Cetak

2. Installed height of the Bike Rack will be determined

based on the size of the bicycle to be mounted. To

determine the best installed height, place the largest

bicycle on the rack by placing the vertical frame member

(see Diagram #3) in the outer V-block carrier (see

Diagram #1).

The front wheels of the bike(s), when

mounted, must be at or above the bottom of the vehicle

bumper. If mounted lower, the bikes may drag when the

vehicle goes up or down a ramp. If height is a concern,

remove the bike(s), remove the Bike Rack and move the

Bike Rack up to the next step of the ladder; replace

bike(s) to check fit. When operating height has been

determined, remove bike(s) and continue with Bike Rack

installation.

3. With your Bike Rack attached onto the proper step of

your ladder, center it between the rails of the ladder.

MAY CAUSE PERSONAL INJURY OR PROPERTY

Failure to properly secure the Bike Rack to the ladder

may cause damage or injury. Always verify that the

Bike Rack is securely fastened to the ladder.

4. Install (1) 42" strap with Superlock buckle by placing

the strap around two steps of the ladder above and

below the lower crossbar of the Bike Rack as shown

below, with the buckle in the straight section of the strap

between the upper and lower step and behind the

ladder. Pull on the end of the strap until strap is tight.

CAUTION

DAMAGE