Comtek BST-75 Panduan Operator - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemancar Comtek BST-75. Comtek BST-75 16 halaman. Synthesized base station transmitter
Halaman Cetak
BST-75 SPECIFICATIONS
Audio Inputs:
•
Line level balanced input
0 dBm for 80% modulation
(+20 dBm max)
•
Electret mic unbalanced input
-25 dBV at 5 k for 80% modulation
Connectors:
•
XLR-3F Combo with 1/4"
phone jack
•
Barrel type 5.5mm X 2.1mm
power jack AC or DC
•
BNC type RF output
Operation Indicators:
•
LED bargraph VU meter
•
LED antenna load and coaxial
cable condition indicator
•
LED DC power indicator
Antenna:
•
19" Telescopic antenna mounts
directly into top of transmitter
•
BNC RF output connector for
optional external antenna
FCC Compliance:
Type Accepted under FCC
Part 90
Power Requirements:
12 Volts AC or DC, 200 mA max
Frequency Response:
80 Hz to 10 kHz
Audio Distortion:
Less than 0.5% at 80% modulation
Modulation Limiter:
Peak compressor type with
high linear overload protection
(25 dB). Attack time less than
1 ms, recovery time 10 ms
Audio Processing:
Companded and non-companded
to accommodate a variety of
receivers
Audio Gain Control:
Limited to 20 dB
Frequency Modulation:
10 kHz deviation for
narrow band companded
RF Output Power:
Maximum power output for
FCC Part 90 (120mW)
Frequency Stability:
Better than 0.002% digitally
synthesized, crystal controlled
Operating Frequency:
72.020 to 75.980 MHz
88 "Flash Memory"
programmable channels
Harmonic and Spurious Emissions:
Better than 50 dB below carrier
Dimensions:
3 3 /4" X 1 5 /8" X 5 1 /4" deep
Weight:
15 1 /4 oz.
Page 12
NOTE: Specifications subject to
change without notice