Comtel AGM Sentinel Petunjuk Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Sensor Keamanan Comtel AGM Sentinel. Comtel AGM Sentinel 2 halaman.
Halaman CetakPrepare for AGM Sentinel deployment
Open AGM Sentinel case and install 4 "C" Cell
•
alkaline batteries.
Following instructions in AGM Explorer software,
•
connect AGM Sentinel to computer.
Using software, set up AGM Sentinel for run
•
adjusting friendly name and serial number as
needed.
Clear data for next run. (Caution: This will erase all
•
previously logged data. Ensure previous data is no
longer required or has been downloaded for the
previous run.)
Power off AGM Sentinel and disconnect from
•
computer.
Close case.
•
Deploying the AGM Sentinel
Position AGM directly above pipeline
•
Ensure AGM is parallel to pipeline
•
For reference see direction label on AGM Sentinel
•
case
Note Asset number for satellite transponder to
•
access satellite data
Turn AGM Sentinel on by depressing the pushbutton
•
on side of AGM case for approximately 2 seconds
The status light on the power button will turn on
•
solid to indicate the AGM Sentinel is on and
obtaining GPS time and location.
The status light will blink once every 2 seconds
•
when the AGM is ready to log and looking for a pig
passage.
Passage Logging
The status light will blink rapidly when the AGM
•
Sentinel detects and is logging a pig passage.
Note: The AGM Sentinel is very sensitive and will
sometimes log noise sources, vibration or moving
magnetic fields other than pig passages. This will not
prevent it from logging the actual passage.
The status light will blink 3 times every two seconds
•
when it senses a 22 Hz transmitter passage.
The AGM Sentinel will continue to log until is it turned
•
off.
This enables it to record multiple pig passages.
•
Retrieving the AGM Sentinel
Turn off the AGM Sentinel by holding down the power
•
button for approximately 2 seconds.
The status light on the power button will turn off.
•
Following instructions in AGM Explorer software,
•
connect AGM Sentinel to computer.
Download the data log from the AGM Sentinel into the
•
AGM Explorer software. This will allow you to view the
log and determine pig passages.
See the AGM Explorer software for more information
•
on how to view and use the AGM data.
Note: The data in the AGM is stored even if the
•
batteries are removed until the data is downloaded or
deleted using the AGM Explorer software.
AGM Software
•
Use the AGM Explorer software supplied by Comtel Systems
to adjust settings and download data from the AGM Sentinel.
•
For more information on adjusting settings and downloading
data, please refer to the HELP section in the software.