Aube Technologies CT241 Petunjuk Instalasi dan Panduan Pengguna

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Panduan Pengguna untuk Pengontrol Aube Technologies CT241. Aube Technologies CT241 2 halaman. Telephone controller

Halaman Cetak

I n stall ati on I n stru c tion s and U ser M an u al

1 . Introduction

The CT241 telephone controller is designed to remotely control up to

four independent loads.

For example, you could connect a sprinkler system, a water heater,

etc. Another example would be to connect an output to the thermo-

stat's phone interface (which requires a dry contact) to switch from

Comfort mode to Vacation mode and vice versa.

Loads can be activated or deactivated remotely (by telephone) or

manually (on-site).

Power Indicator. Indicates the CT241 is powered on. To turn

it off, unplug the power transformer.

Communication Indicator. Indicates the CT241 has

answered and is awaiting a command.

Ring Indicator. This indicator flashes when the phone rings.

Reset. This button can be used to reset the CT241 to its

default values. See section 3.2.

Manual Output Activation Button. Can be used to manually

activate or deactivate a relay.

Terminal Board. See section 2.

2. Installation

Any device connected to a telephone line must conform to the coun-

try's standards. The CT241 telephone controller meets:

• FCC68 standards for installation on the North American network.

• FDTBR21 standards for installation on the European network.

2.1 Included Parts

• One CT241 telephone controller)

• One power transformer 120 V (North America) or 250 V (Europe)

• One 5 m (16 foot) telephone cable

2.2 Installation Procedure

NOTE:

If you are using an answering machine, position the answer-

ing machine switch to ON before installing the CT241. Make sure that

your answering machine answers after a minimum of 4 rings.

CT241 Telephone

Controller

Mount the CT241 near a telephone outlet.

NOTE:

If you plan to connect a load having more that 30 volts on the

auxiliary outputs, the CT241 must be installed inside a certified elec-

trical box.

OPTIONAL. Connect your phone (or answering machine) to the

PHONE connector of the CT241.

Connect one end of the telephone cable to the LINE connector of

the CT241 and the other end to the telephone outlet in your

home.

Connect the loads.

The four outputs of the CT241 allow you, for example, to activate

or deactivate the lighting system, the sprinkler system, the water

heater, etc.

You can also connect a thermostat's telephone interface (which

requires a dry contact) to automatically switch from Comfort

mode to Vacation mode and vice versa.

NOTE:

The capacity per output is 10 A @ 240 VAC. However, to

avoid electrical shocks, the direct connection of a load exceeding

30 VAC is not permitted unless the CT241 is installed inside a certi-

fied electrical box.

When all connections have been made, connect the power

transformer to the 9 V outlet of the CT241 and the other end to

the wall electrical outlet.

The power indicator light

is ON when the circuit is powered.

400-241-001-A