Auber WSD-1203CPH Panduan Pengoperasian & Instruksi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengoperasian & Instruksi untuk Pengontrol Suhu Auber WSD-1203CPH. Auber WSD-1203CPH 12 halaman. Programmable pid temperature controller with dual probe

Halaman Cetak

The display will go the step 2 setting. It will repeat in the same way as the step 1. After

you program enough steps for your recipe, you can program the rest of the steps of E0X

to t and set t0X to zero.

The temperature setting will not be changed if SET is not pressed (confirmed). After

programming the necessary steps for cooking, you can finish programming by pressing

the SET continuously until it passed T06 and display the current temperature. You can

also leave the controller alone. The display will return to the normal display mode if no

key is pressed within 15 seconds.

The initial program setting for the controller is listed in

Table 1. This program will control the temperature of the cabinet at 120 °F for 2 hours.

Then, change the temperature to 190 °F. It will stay at 190 °F until internal temperature of

the meat reaches 160 °F. Then, the controller will drop the temperature to 130 °F for 30

hours, waiting for you to pick up the food. If you set C03=0 and t03=0, when meat

internal temperature reaches 160 °F, the controller will shut off the heater, flashing END

on both windows, and turn on the beeping alarm to notify you that cooking is finished.

Table 1. Initial program setting

Step #

C01

C02

C03

C04

C05

C06

The smoker generator power is controlled by parameters R1 and R2 which can be

accessed by code 166 (see section 7). The generator can be turned on for two steps. R1

is for the first step. R2 is for the second step. e.g. To turn on the smoker generator at step

1 and 3, set R1=1 and R2=3. If you only want to use one step, set either R1 or R2 to 0,

and set the other one to the step you want to turn on the smoker generator. The initial

setting for the controller is to turn on the generator at step 1 only.

4. Check the current step and display the time

To check which step the program is at during cooking, press the "+" Key (8) once. The

left window will show the current step in the form of P0X on. e.g. It will display P03 if the

controller is at step 3. The display will return to the temperature display automatically

after 8 seconds. To check how long the controller has been running since powered up,

press the Time key (9) once. The Timer status indicator will light. The right window will

Temp (F)

Step #

120

E01

190

E02

130

E03

E04

E05

E06

F or T

Step #

t01

F02

t03

t04

t05

t06

value

2.0

160

30.0

0.0