Auber Instruments WS-1211GPH Panduan Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Pengontrol Suhu Auber Instruments WS-1211GPH. Auber Instruments WS-1211GPH 12 halaman. Programmable precision pid temperature controller
Halaman Cetak
Figure 5. Sensor position. Left, the sensor should be placed close to the food but high enough so
that it does not touch the food. Right, hold the sensor in place by a piece of tape.
For the "Original" and Stainless Steel Bradley smoker, the Temperature Heat Control Switch on
the smoker tower should be slide to the Hi position (Most right).
For the Bradley Digital Smoker, the original sensor cable from the smoker should be connected
between the generator and smoker.
The controller is ready to power up.
3. Programming the temperature profile.
A total of 6 steps can be programmed for this controller. Each step contains the temperature (C-
X) and time duration (t-X) setting. They are represented by the symbol C-X and t-X, where "X" is
the step number (e.g. temperature value of Step 4 is represented by C-4 and time value of step
4 is represented by t-4). The character, "t", is displayed as the symbol, "T". Time is defined as the
duration between the last step and the next step. Please make sure the time is long enough for
the heater to heat up the oven. If the time is set too short, the temperature may not be able to
reach set temperature, before it jumps to the next step. The time unit is in minutes with 1 minute
resolution. If the recipe only needs one step, you can program the time of the rest of the steps to
zero.
To program the temperature profile, press SET key once. The display will show C-1 for one second
and then display the temperature setting for step 1. Use "+" and "-" keys to change the setting.
When finished, press the SET again to confirm the change. The display will show t-1 for a second
and then change to the time setting for step 1. Use "+" and "-" keys to change the setting. When
finished, press the SET again to confirm the change. The display will go to the step 2 setting. The
following is the flow chart for the setting procedure.
The temperature setting will not be changed if SET key is not pressed (confirmed). After
6