AuCom CSX-022 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol AuCom CSX-022. AuCom CSX-022 12 halaman.
Juga untuk AuCom CSX-022: Panduan Pengguna (13 halaman)

Halaman Cetak

CAUTION STATEMENTS

1.
Caution Statements
Caution Statements cannot cover every potential cause of equipment damage but can
highlight common causes of damage. It is the installer's responsibility to read and understand
all instructions in this manual prior to installing, operating or maintaining the equipment, to
follow good electrical practice including applying appropriate personal protective equipment
and to seek advice before operating this equipment in a manner other than as described in
this manual.
Isolate the CSX completely from the power supply before attempting any work on the
CSX or motor.
Cables to the control inputs must be segregated from mains voltage and motor cabling.
Some electronic contactor coils are not suitable for direct switching with PCB mount
relays. Consult the contactor manufacturer/supplier to confirm suitability.
Do not apply incorrect voltages to the control input terminals.
Do not connect power factor correction capacitors to the output of CSX soft starters. If
static power factor correction is employed, it must be connected to the supply side of
the soft starter.
WARNING - ELECTRICAL SHOCK HAZARD
The CSX contains dangerous voltages when connected to mains voltage. Only a
qualified electrician should carry out the electrical installation. Improper installation of
the motor or the CSX may cause equipment failure, serious injury or death. Follow
this manual and local electrical safety codes.
AVERTISSEMENT - DANGER D'ELECTROCUTION
Le CSX contient des tensions dangereuses lorsqu'il est raccordé à l'alimentation
secteur. Seul un électricien compétent peut effectuer l'installation électrique. Une
mauvaise installation du moteur ou du CSX peut déclencher une panne
d'équipement, provoquer de graves blessures ou même la mort. Suivre les instructions
de ce manuel et des codes locaux concernant la sécurité électrique.
GROUNDING AND BRANCH CIRCUIT PROTECTION
It is the responsibility of the user or person installing the CSX to provide proper
grounding and branch circuit protection according to local electrical safety codes.
SHORT CIRCUIT
The CSX is not short circuit proof. After severe overload or short circuit, the
operation of the CSX should be fully tested by an authorised service agent.
2
CSX User Manual
710-02407-00J