daltile DG5 Panduan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penggiling daltile DG5. daltile DG5 12 halaman.

Halaman Cetak

1. INSTALLING THE

GRINDING DISK

Turn off and unplug the machine before moun-

ting or replacing the grinding disk. Never use a

grinding disk with a lower RPM than that of your

angle grinder (See specifications).

1) Turn the machine over with the spindle

facing upward and mount the flange.

Rotate the flange until you feel it locking.

2) Mount the grinding disk.

3) Screw the wheel nut onto the spindle

by hand

4) Lock the spindle and tighten the wheel nut

using the wrench

5) To remove the grinding disk follow these

procedures in reverse order.

Wrench

Wheel Nut

Grinding

disk

Flange

Blade guard

Spindle

Spindle lock

Always use the blade guard and safety goggles

when operating this machine

PAGE 10 DALTILE ANGLE GRINDER OPERATING MANUAL V09/2005R1

OPREATING INSTRUCTIONS

2. GRINDING PROCESS

1. Grinding pressure

Apply only a little pressure to grinding disk.

Excessive pressure on the grinding disk will

decrease grinding speed and cause a rough

surface finish and may cause overheating of the

motor and machine failure.

2. Grinding angle

Do not apply the total surface of the grinding

disk to work material. Efficient grinding is

achieved by keeping the angle between cutting

blade and work material at 15° to 30° as shown

in the picture.

3. CAUTION AFTER USE

Immediately turn off the machine after finishing

your work and store it in a safe place. Do not let

the machine run freely in a dust filled space.

Dust may end up in the motor and cause dama-

ges.

Grinding disks may damage on impact. Always

inspect grinding disks after impact and replace

when damaged.