AIRTUG 10-H Petunjuk Perakitan & Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Perakitan & Pengoperasian untuk Peralatan Pertanian AIRTUG 10-H. AIRTUG 10-H 4 halaman.

Airtug® /

/ 216-941-9781 / www.airtug.com

Note: 10-H Models (hydraulic) - Using the lever on the jack, raise the Airtug platform up an inch or two

prior to moving the aircraft. Close the valve and pump the jack handle for "up" operation and open the

valve to lower the platform. Verify winch strap tension prior to moving the aircraft.

Aircraft Unloading:

Chock the aircraft ﬁrst if necessary. Disconnect the strut strap or "J" hook

from the aircraft and secure the winch strap to the tug. Gently pull the tug away from the aircraft.

Note: 10-H Models (hydraulic) Open the jack valve to lower the tug platform prior to unloading the

aircraft.

General Maintenance

Tire Pressure:

The tire pressure can range from 30psi for lighter aircraft in the 3,000 pound range

to 70psi for heavier aircraft up to 16,000 pounds

Battery:

Keep the battery fully charged. Chargers are available by calling Airtug at 216-941-9781.

Hydrostatic Transaxle:

This should be checked for oil level. Add 20W-50 oil if level is low.

Drive Wheel Bearings:

Permanently lubricated.

Caster Zerk Fittings:

Needs to be lubed periodically to ensure ease of caster wheel steering.

Drive Chains:

Apply chain lube periodically depending on use and environment.

Tractive Ability:

If the tug seems to be losing tractive ability, it's an indication of a loose drive belt.

The engine plate is mounted on slotted holes and can be moved rearward to tighten the drive belt if

necessary. Simply loosen the nuts, push the engine plate towards the rear of the tug and tighten the

nuts ﬁrmly.