ADDER ADDERLink INFINITY 2100 Mulai Cepat
Jelajahi secara online atau unduh pdf Mulai Cepat untuk Pemanjang ADDER ADDERLink INFINITY 2100. ADDER ADDERLink INFINITY 2100 2 halaman.
Juga untuk ADDER ADDERLink INFINITY 2100: Mulai Cepat (2 halaman)
Halaman CetakALIF2100 configuration via web pages
Each ALIF2100 unit hosts its own internal set of web pages which contain all configuration details
and settings. You will need to use a computer connected to the same network as each ALIF2100
unit to access the web pages. Additionally, on the console attached to the ALIF2100 RX unit, you
can access its configuration details via the On Screen Display (OSD) by pressing CTRL + ALT + C
To configure ALIF2100 units via their web pages
Run a web browser on your computer and enter the IP address of the required ALIF2100 unit:
The default addresses (if using port 1) are
The default addresses (if using port 2) are
The opening page should be displayed:
Full user details and setup instructions can be found at:
www.adder.com/en/kvm-solutions/adderlink-infinity-2102
www.adder.com
© 2023 Adder Technology Limited • All trademarks are acknowledged.
Part No. MAN-QS-000055_V1.1
TX: https://169.254.1.33
RX: https://169.254.1.32
TX: https://169.254.1.43
RX: https://169.254.1.42
ADDERLink
Welcome
This quick start guide covers some of the key points of the ADDERLink™ INFINITY 2100 unit. Full user details
and setup instructions can be found at www.adder.com/en/kvm-solutions/adderlink-infinity-2102
Please read the supplied safety instruction leaflet before use.
Initial configuration
ALIF2100 units can be linked in two mains ways: Direct or Networked.
Direct linking
Where ALIF2100 transmitters and receivers are directly linked to each other, very little configuration
action is required, provided that they both have their factory default settings in place - just link them
together. If the standard settings have been changed in a previous installation, you merely need to
perform a manual factory reset on each unit. Please see the center pages.
Networked linking
Where ALIF2100 units are connected via networked links, you can either configure them individually,
or configure them collectively using an AIM server:
• Configuring networked ALIF units individually - You need to specify the network addresses
of the ALIF2100 units so that they can locate each other. This can be done using via OSD on the
console connected to the RX unit by pressing CTRL + ALT + C. Please see the rear page.
• Configuring networked ALIF units collectively - The ADDERLink™ INFINITY Management
(AIM) server allows you to configure, control and coordinate any number of ALIF transmitters and
receivers from a single application. See adder.com for details.
Note: If you are using one or more ALIF2100 transmitters
within an installation managed by an AIM server, the AIM
server must be running firmware version 5.3 or above.
IMPORTANT: When using AIM to configure ALIF units, it is
vital that all units that you wish to locate and control are
set to their factory default settings. Otherwise they will
not be located by the AIM server. If necessary, perform a
manual factory reset on each ALIF unit. See center pages.
INFINITY 2100
™
Quick Start