Dan D'Agostino MasterPower 2+ Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Dan D'Agostino MasterPower 2+. Dan D'Agostino MasterPower 2+ 18 halaman. Power amplifiers

Halaman Cetak

1. Specifications

All-pass (bypass) mode

Setting the slider in the middle position puts the channel in all-pass

(bypass) mode. No filtering will be applied and the channel will run full-

range.

Operation

Initial power-up of the amplifier

To power-up the amplifier, simply push the power button located on the front of the

amplifier. The LED inside the button will light up. If you are using the 12-volt trigger input,

powering up the connected component will turn the power on for the amplifier.

After power is switched on, the Master Power 3+ and Master Power 2+ amplifiers require

approximately 30 minutes to reach optimal operating temperature. Although the amp will

sound excellent upon initial listening, the sound quality will improve as it warms up, much

as the flavor of a fine red wine improves if it is allowed to breathe for a few minutes.

Maintenance

The Master Power series amplifiers requires no user maintenance other than to keep the

amplifier clean and ensure its vents remain unobstructed.

To clean the amplifier, spray a small amount of distilled water onto a microfiber cloth and

gently wipe the amp's surface along the direction of the metal grain, with light pressure

only. Never use heavy pressure, as this can permanently scratch the surface. Do not rub the

surface with the cloth, and do not spray any liquid directly onto the integrated amp.

If dust or other contaminants or objects collect around the vents at the top and bottom of

the integrated amp, remove small objects by hand and use a shop vacuum or hand

vacuum to remove the dust. Use a brush attachment on the vacuum to avoid scratching

the integrated amp's surface.

If you should need to transport or ship the amplifier, be sure to use the original packing

materials. Allow the amp to cool down for at least one hour before you wrap or package it.