Dan D'Agostino MasterPower 2+ Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Dan D'Agostino MasterPower 2+. Dan D'Agostino MasterPower 2+ 18 halaman. Power amplifiers
Halaman Cetak5
Package contents
If any of the following items are missing, please contact your dealer:
1 Master Power 3+ or Master Power 2+ amplifier encased in protective static cling vinyl
3 XLR-to-RCA adapters
1 owner's manual
1 AC power cord
Unpacking the Master Power 3+ and Master Power 2+ amplifiers
The Master Power 3+ and Master Power 2+ amplifiers weigh well in excess of 100 pounds,
so they are too heavy for one person to lift safely. To unpack the amp, first move the box
near to a location near where it will be installed. Remove anything from your person that
might scratch the amplifier's finish, such as watches, rings and belts with metal buckles.
Two people should lift the amplifier onto a soft surface, such as a towel or blanket. Lay the
amp on its back, carefully remove the plastic wrap, then turn the amplifier upright and sit it
on its feet. You can now place the amplifier on the stand or rack you'll be using.
Installation requirements
Because these amplifiers are extremely heavy—128 pounds for the Master Power 3+, 108
pounds for the Master Power 2+—please make sure the surface that will support the
amplifier can safely hold its weight.
Adequate ventilation must be provided for the amplifier. There should be at least 3 inches
of clearance on each side and 3 inches of clearance at the top. The bottom vents must not
be obstructed by thick carpet, dust, etc. We recommend that the amp be installed in an
open equipment rack to assure proper ventilation. The amp may be installed in a closed
cabinet or in an equipment closet, but the cabinet or closet must be designed with
substantial ventilation at top and bottom; active ventilation (i.e., powered fans) is
preferred. Do not place the amplifier directly on a carpeted floor (we recommend using a
rack or an amplifier stand if the floor is carpeted), and make sure that dust is not allowed
to accumulate around the amplifier.
Do not plug the Master Power 3+ or Master Power 2+ amplifier or any other Dan
D'Agostino Master Audio Systems product into a power strip or power conditioner.
If you need to return the amplifier for service
If you should need to send the Master Power 3+ or Master Power 2+ amplifier back to us
for service, be sure to use the original box and materials for shipment.
Before you ship the amplifier, unplug it from the wall and let it cool down for 6 hours. To
protect the finish during shipping, rewrap the amplifier in the vinyl covering it came in.
Make sure the amp is completely cool and has not been plugged in for 6 hours before you
do this. Wrapping the amplifier when it is warm will cause the vinyl to leech into the
amplifier's surface and will permanently damage the finish.