DAN DRYER 244 Turbo Panduan Pemeliharaan dan Servis - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemeliharaan dan Servis untuk Pengering DAN DRYER 244 Turbo. DAN DRYER 244 Turbo 12 halaman.

Reference

Version

244-ENG

09-01-2018

Cleaning the inside of the machine

7. Use compressed air (max. 8 bar) to remove dirt

and carbon dust from the motor and motor

housing. If compressed air is not available,

parts may be cleaned with a soft brush or

gently with a vacuum cleaner.

8. Lift the large rubber gasket out of the top of the

motor housing. Clean it and degrease with alcohol.

Clean the small rubber gasket placed at the bottom

of the motor housing in the same manner.

9. The heating element is placed at the bottom of

the motor housing. Clean it using compressed air

(max. 8 bar). Blow from both sides, and be

careful not to damage the heating element.

DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: [email protected]

Document

244 DAN DRYER Turbo (with nozzle)

Maintenance and service manual

Lang.

ENG

10. Put the small rubber gasket back in place at

the bottom of the fan housing. Be careful

not to turn it upside down, cf. photo ref. 11.

11. Put the motor back in the bottom part of

the fan housing. Make sure that the motor

rests properly between the two "forks"

and on the small rubber gasket.

12. Reconnect motor wires to the timer unit

(appearance depends on the timer type).

Please be careful not to damage wires.

Page

7 of 12