Dan's Comp Front Load Stem Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Sepeda Dan's Comp Front Load Stem. Dan's Comp Front Load Stem 5 halaman.
Halaman Cetak•
Thread the headset compression bolt and cap back into the top
of the fork steerer tube.
•
Tighten the compression bolt so that the headset cap makes
contact with the top to the stem.
These instructions are to be used as a guide only. Improperly installed parts may lead to severe injury or harm. We strongly recommend that
a properly trained bike mechanic handle all installations, adjustments and repairs on your bike. As always...Ride Safe!
AMain.com Inc.
Front Load Stem Installation
Add or remove headset spacers
•
You should have approximately ¼ of an inch from the top of
the fork steerer tube and the top of the stem opening.
•
If you have more than ¼ of an inch, if possible, remove one or
more of the extra headset spacers.
•
If you have less than ¼ of an inch, add one or more headset
spacers.
Note: Headset spacers come in different sizes.
Adjusting the Headset
•
Spin the forks and stem to determine how much the headset
needs to be adjusted.
•
If the headset has play in it, you'll need to tighten the
compression bolt/cap. If the headset is too hard to spin, you'll
need to loosen the compression bolt/cap. You may need to spin
them a few times until you have it adjusted.
•
Slightly tighten the pinch bolts but do not fully tighten them
yet.
Note: Do not over-tighten the compression bolt/cap! You can
damage the fork and/or the headset bearings.
1-844-970-4269
www.danscomp.com
Page 3