Concept Perugini XS 125 Buku Instruksi - Halaman 9
Jelajahi secara online atau unduh pdf Buku Instruksi untuk Peralatan Pertanian Concept Perugini XS 125. Concept Perugini XS 125 18 halaman. Verge flail mowers
Halaman Cetak
PTO Shaft
If necessary, cut the PTO shaft to the right length following the shaft
manufacturer instructions.
When attaching the PTO shaft to the machine and tractor make certain that if the
PTO shaft is fitted with an overrun clutch this must be installed on the implement.
When connecting to the tractor verify that the locking pin is correctly located and
secure in place. Before use make sure all the chains and guards are correctly
fitted.
Working Depth
The height of the machine from the ground is controlled by the rear roller, skids
and top link. Before using the flail mower make sure that the flails do not hit the
ground, this will result in extreme wear and will damage the rotor.
A
A
B
A
A
B
C
C
1
2
3
CS have the supports pictured in fig.1 to alter the height of the roller simply
slacken bolt A, remove C and reposition the support in B. Tighten all bolts.
XS model has the supports pictured in fig.2. Slacken A remove C, reposition the
support in the desired height (B or C).
ES has the roller brackets shown in fig.3. Undo bolts A move the plate to the
desired height and tighten bolts A. Depending on the width of the machine the
plates may be either on the inside of the chassis or the outside.
9