ADDER ALIF100T Mulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Mulai Cepat untuk Pemanjang ADDER ALIF100T. ADDER ALIF100T 2 halaman.

ADDER ALIF100T Mulai Cepat
Connections
Black USB plug provides USB
signals (plus power if the
external power adapter is not
present)
Warranty
Adder Technology Ltd warrants that this product shall
be free from defects in workmanship and materials for a
period of two years from the date of original purchase.
If the product should fail to operate correctly in normal
use during the warranty period, Adder will replace or
repair it free of charge. No liability can be accepted for
damage due to misuse or circumstances outside Adder's
control. Also Adder will not be responsible for any loss,
damage or injury arising directly or indirectly from the
use of this product. Adder's total liability under the terms
of this warranty shall in all circumstances be limited to
the replacement value of this product. If any difficulty is
experienced in the installation or use of this product that
you are unable to resolve, please contact your supplier.
Cable tie
mounting slot
Status
indicators
(see below)
Reset button
(see below
right)
Red USB plug provides power
only when the external power
adapter is not present
Main status indicators
• Off
No power
• Green
Operating - Video, USB and network link all
present
• Orange
Operating - But video, USB and/or network link
missing.
• Red
(momentarily) Unit is booting up, or
(consistently) Unit has failed, try rebooting.
• Red/green flashing
Unit is in backup mode.
• Blue
Factory reset has been activated.
• Red/blue flashing
Unit is in upgrade mode.
• Fast green flash
Unit is in identify mode.
AdderLink Infinity browser-based configuration utility
Use this utility when configuring the ALIF100T to work with ALIF receivers
which are linked via a network. You will need to use a computer connected to
the same network as the ALIF100T unit (you can also connect them directly).
To access the browser-based configuration utility
Run a web browser on your computer and enter the standard IP address of the
ALIF100T unit:
169.254.1.33
Note: If the IP address of ALIF100T unit has been changed and is not known, providing
it is appropriate to do so, perform a manual factory reset (see below) to restore the
default address.
The opening page of the ALIF configuration utility should be displayed:
DVI-D (or DisplayPort)
connector input
Optional external
power input
Ethernet port (plus
indicators) - Either link
directly to an ALIF receiver
or via a network switch
Full user details and setup instructions can be found at:
www.adder.com/en/kvm-solutions/adderlink-infinity-100t
To perform a manual factory reset
A factory reset returns ALIF100T unit to its default configuration.
1 Power on the ALIF100T unit.
2 Use a narrow implement (e.g. a straightened-out paper clip) to press-and-
hold the recessed reset button on the front panel for roughly fifteen seconds,
until the status indicators turn blue (Note: alternating red/green indications will
occur during the fifteen second period while the button is still pressed).
3 Release the reset switch. The indicators will remain blue for a short while
(less than ten seconds) while ALIF100T unit configures itself and should then
change to green if all connections are correct; or orange if one or more of
the video, USB and/or network links are missing.
NOTE: If you are performing a factory reset and intend to disconnect the
power immediately after the reset, you must wait at least 30 seconds after
you have released the reset button for it to complete the process.