3onedata IES215-P Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Jaringan 3onedata IES215-P. 3onedata IES215-P 4 halaman. Ies215 series industrial ethernet switch

Halaman Cetak

The switch top panel provided 3 bit power supply input

terminal block, support DC input. Reverse connection

protection. Voltage input range is 9～48VDC (terminal block

defined as, 1: V+, 2: FG, 3: V-).

AC Series Switch:

The singe power AC series top panel provides 3 bit terminal

block for 100~240VAC power input (1: L/+, 2: FG, 3: N/-)

Important notice:

1. Power ON operation: first of all, insert power cable's

terminal block into device's power port, then insert power

supply plug into power source.

2. Power OFF operation: First off all, unpin power plug, then

strike the terminal block, please take care of operation

sequence.

【DIP Switch】

Top panel provided 4 bits DIP switch to do function configure

(ON to enable effective). 1 is RJ45 port support pause frame

flow control and the optic fiber port support back press flow

control. 2 is RJ45 force 10M. 3 and 4 is reserved.

【Dimension】

The series of products are the same size, and the number of

interface is different.

Unit (mm)

【Communication connector】

10/100BaseT(X) Ethernet port

The pinout define of RJ45 port display as below, connect by

UTP or STP. The connect distance is no more than 100m.

100Mbps is used 120Ω of UTP 5, 10Mbps is used 120Ω of

UTP 3, 4, 5.

RJ 45 port support automatic MDI/MDI-X operation. Can

connect the PC, Server, Converter and HUB .Pin 1,2,3,6

Corresponding connections in MDI. 1→3, 2→6, 3→1, 6→2

are used as cross wiring in the MDI-X port of Converter and

HUB. 10Base-T/100Base-TX are used in MDI/MDI-X, the

define of Pin in the table as below.

NO.

MDI signal

TX+

TX-

RX+

RX-

4, 5, 7, 8

—

Note： , "TX±"transmit data±, "RX±"receive data±, "—"not use.

- 2 -

10/100Base-T(X) MDI (straight-through cable)

10/100Base-T(X) MDI-X (Cross over cable)

MDI/MDI-X auto connection makes switch easy to use for

customers without considering the type of network cable.

100Base-FX SC/ST/FC port

100Base-FX port support full-duplex SC/ST/FC Multi mode

or Single mode. The fiber port TX(transmit) connect remote

RX(receive).

Suppose: If you make your own cable, we suggest labeling

the two sides of the same line with the same letter (A-to-A

and B-to-B, shown as below, or A1-to-A2 and B1-to-B2).

MDI-X signal

RX+

RX-

TX+

TX-

【LED Indicator】

—

LED indictor light on the front panel of product, the function

of each LED is described in the table as below.