3onedata IES308 Panduan Pemasangan Perangkat Keras - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Router Jaringan 3onedata IES308. 3onedata IES308 10 halaman.

Run

10/100BaseT(X) Ethernet port state LED

10M/100M

（yellow）

Link/ACT

（green）

Relay contact:

The relay consists of the two middle contacts of the terminal block

on IES308 series's top panel. The two terminal block connector are

used to detect both power faults and port faults. The two wires

attached to the Fault contacts form an open circuit when:

(1) IES308 series have lost power from one of the DC power inputs,

One of the ports for which the corresponding Port alarm DIP Switch

is set to ON is not properly connected.

If neither of these two conditions occur , the alarm circuit will be

closed.

Your Serial and Data Communications Expert

OFF

100Mbps is active(100Base-TX)

OFF

10Mbps is active(10Base-T)

TP port is active

Blinking

Data is being transmitted

OFF

TP port is inactive

Power and the port's link is

active, not alarm

Common straight link mode

disable

Shenzhen 3onedata Technology Co.,Ltd