ADDER ALIF1000 Panduan Memulai Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar ADDER ALIF1000. ADDER ALIF1000 4 halaman. Transmitter and receiver
Juga untuk ADDER ALIF1000: Panduan Memulai Cepat (4 halaman)
Halaman Cetak
RX (receiver) unit configuration
In the ALIF system, the RX unit determines where and how data
signals are sent (and received) by the TX unit. Although numerous
ALIF topologies (one-to-one, one-to-many, many-to-one, etc.) are
made possible, they are all dependent on two underlying modes of
operation: either Unicast or Multicast transmission. Where multicast
transmission is not invoked for video and/or audio data, operation
will be automatically served by unicast network transmission
technologies.
Configuring the RX unit
1 Display the System Configuration page of the Infinity browser-
based configuration utility.
2 Ensure that the IP address and netmask for this RX unit are correct.
The System IP Address set here will be sent to the TX unit as the
destination for transmitted data (when in unicast mode).
3 Check that the data streams (Video TX, Audio TX/RX and USB
TX/RX) are enabled (ticked) or disabled (unticked) as appropriate.
There are similar options within the Infinity TX unit configuration
and it is important that the settings in both units are the same.
4 In the Remote Unit Settings section, enter the IP address for the
TX unit that will be supplying the video, audio and USB data
streams. Most often all three streams are supplied by the same
TX unit, however, it is possible to receive them from different
locations (click the blue arrow to reveal the separate addresses).
Adder Technology Limited,
Saxon Way, Bar Hill,
Cambridge, CB23 8SL,
United Kingdom
Tel: +44 (0)1954 780044
Fax: +44 (0)1954 780081
www.adder.com
5 For installations that will include more than one RX unit, you also
need to configure the Multicast Settings section.
The Video and Audio sections are configured in the same way:
• Tick the Enable Multicast Video / Enable Multicast Audio box.
• Next, enter an appropriate Multicast Address for the Video/
• Click the Update Now button to save.
Repeat the IP addressing and multicast configuration steps for all
RX units that will be part of the one-to-many installation.
For most installations, the successful implementation of these
configuration steps will result in a correctly working system.
Adder Corporation,
Adder Asia Pacific,
350R Merrimac Street,
8 Burn Road,
Newburyport,
#04-10, Trivex,
MA 01950,
369977, Singapore
United States of America
Tel: +65 6288 5767
Tel: +1-888-932-3337
Fax: +65 9616 1283
Fax: +1-888-275-1117
Audio data stream(s). The IP addresses between 224.0.0.0
and 239.255.255.255 are specifically reserved by networks for
multicast operations.
The address that you enter will be used by the RX unit to
'listen-in' on the data stream from the TX unit. This same IP
address needs to be set on every RX unit that will similarly
receive the data stream. The video and audio multicast
addresses can be the same or different, as required.
IMPORTANT: Please see the full Infinity user
guide for safety, warranty and regulatory
information. The full user guide is supplied
on the CD-ROM with the unit and is also
available from www.adder.com.
© 2011 Adder Technology Limited • Release 1.1b
All trademarks are acknowledged.
MAN-ALIF-QUICK