Duco DucoBox Focus Panduan Instalasi - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kap Ventilasi Duco DucoBox Focus. Duco DucoBox Focus 20 halaman.
Juga untuk Duco DucoBox Focus: Panduan Pengguna (2 halaman), Panduan Instalasi (16 halaman), Mulai Cepat (4 halaman)
Halaman Cetak
ENGLISH
07.D Removing / replacing components
Removing paired components from the network or replacing is only possible within 30 minutes after the component is paired in
or is restarted� Restarting can be done by disconnecting the power for a moment� After a time-span of 30 minutes, remove and
replace operations are ignored� This is valid for all components from date of manufacture 170323�
Removing a component
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green or yellow rapidly�
Press once and hold a button on
the component to be removed in
order to remove it from the net-
2
work� NB: any underlying compo-
nents will also be removed from
the network.
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
07.E Tips
• Removing all components from the network (e.g. in the event of problems): Activate 'Installer mode' and long-press 'INST'
until the LED starts flashing red� The DucoBox will reboot and the LED will stop flashing�
• Restoring factory settings for the DucoBox and all paired components (AS FROM DucoBox version 18xxxx): Long-press 'INST'
and 'ENTER' if not in 'Installer mode'� The network remains in place�
• Use the Duco Network Tool to read out information from components�
14
L2000631 Installation guide for DucoBox Focus (Revision K | 13.07.2020)
Replacing a component
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green or yellow rapidly�
5 sec
Press briefly twice on the button
2
of the component to be replaced�
5 sec
Tap once on the button for the new
component� The latter will take on
3
all settings / connections in the
network�
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
5 sec
OLD
2x
NEW
1x