AnyTone AT-310M Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio AnyTone AT-310M. AnyTone AT-310M 12 halaman.
Halaman Cetak
INSTALLATION
1.
WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO
a)You should choose the most appropriate setting from a simple and
practical point of view
b) Your CB radio should not interfere with the driver or the
passengers.
c) Remember to
provide different wires for the passing and protection
(e.g. power, antenna, accessory cabling) so that they do not in any
way interfere with the driving of vehicles.
d) To install your equipment, use the cradle (H) and the self-tapping
screws [E] provided (drilling diameter 4 mm). Take care not to
damage the vehicle's electrical system while drilling the dash
board.
e) Do not forget to insert the rubber joints [G] between the CB and
its support as these have a shock-absorbing effect which permits
gentle orientation and tightening of the set.
f) Choose where to place the microphone support and remember that
the microphone cord must stretch to the driver without interfering
with the controls of the vehicle.
G)As the transceiver has a frontal microphone socket, it can be set
into the dash board. You will need to add external loud speaker
to improve the sound quality of communications(connector ext.
SP situated on the back panel: D). Ask your dealer for advice on
mounting your CB radio.
E
E
H
G
E
E
H
F
D
B
C
2.
ANTENNA INSTALLATION
a) )Choosing antenna:
-For CB radios, the longer the antenna, the better its results. Your
dealer will help you with your choice of antenna.
b) Mobile antenna:
surface(ground plane) , away from windscreen mountings.
-If you already have a radio-telephone antenna installed, the CB
antenna
should
be higher than this.
-There are two types of antenna: Pre-regulated antenna which should
be used on a good ground plane (e.g. car roof or lid of the boot), and
adjustable antenna which offer a much larger frequency range and
can be used on a smaller ground plane.
contact between the antenna and the ground plane. To obtain this,
you should lightly scratch the surface where the screw and tightening
star are to be placed.
risk of break down and/or short circuiting).
-Connect the antenna to location (B).
c) Fixed antenna:
A fixed antenna should be installed in a space as
possible.
need to keep it as per the requirements of the laws in force (please
turn to professional advice).
F
G
OUTPUT RADIUS PATTERNS
1
spacious
as