anytronics Anyscene 512 Panduan Instalasi dan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pengontrol anytronics Anyscene 512. anytronics Anyscene 512 13 halaman. Scene recall unit
Halaman Cetak5. Multiple Anyscene 512
Up to four Anyscene 512 units can be used within the same DMX installation allowing
smooth transfer of control from one unit to another and providing control of DMX
installations from multiple locations.
Both this pushbutton unit and IR controlled Anyscene 512s may be mixed within the same
system and they may have the same scenes or different scenes stored in each unit.
In normal operation the last activated unit will take over control of the system and provide
the DMX data. After power up, the unit which was last in control of the system will restore
the last selected scene (or auto cycle). If any normal DMX source is connected to the
system, it will take over control of the system and force all the Anyscene 512 units into a
standby/receive state.
To ensure that the scene memory contents remain intact in such multiple unit installations,
it is vital that once scene programming has been completed, the MWP switches on all units
are moved to the ON position. If this is not done, then the units may reprogram each other
when attempting to recall scenes.
5.1. Commissioning
After programming the Anyscene 512s, first test the system by connecting each Anyscene
512 one at a time to check operation over the installed cabling. This is also the procedure
to be followed in case of encountering any problems with the installation to isolate the
problem area.
Once the wiring has been checked, build up the system by adding additional Anyscene
512 units in turn and checking that control of the DMX network is passed smoothly from
one Anyscene 512 to the other when the scene recall buttons are pressed.
The dormant Anyscene 512 units should have their data LEDs lit showing that they are
receiving DMX data from the active unit. The one active Anyscene 512 unit driving the
DMX system should have its data LED extinguished and a scene LED lit.
Units 5 & 6 Hillside Industrial Estate
London Road, Horndean,
Hampshire, PO8 0BL
Tel +44 (0)23 9259 9410
Fax +44(0)23 9259 8723
Page 5 of 13
AT1039 Issue 1
Anyscene 512 Operating
Instructions