Anywave ATSC VHF 100W Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar Anywave ATSC VHF 100W. Anywave ATSC VHF 100W 17 halaman.

3 TX System Overview

Final assembly and test of each transmitter is performed at the Anywave factory.

The Exciter is setup on the desired channel frequency and the TX is tested with the

complete RF system (if purchased) at full power into a load. All TX operating

parameters are optimized and the Transmitter Forward and Reflected power meters are

properly calibrated. Linear and Nonlinear precorrection is performed and automatically

stored in non-volatile memory inside the Exciter. A Factory Test Report is completed

for each system, providing a record of full power operating parameters and performance.

The TX then goes through a final 24-hour burn-in period and check out before being

shut done and packed up for shipment.

In your shipment, you should receive a copy of the following documentation.

- Packing Checklist

- Transmitter Factory Test Report

- 100W TX Quick Start Guide

- 100W PA and Exciter User Manuals

Carefully unpack and inspect all your equipment and please review the Packing

Checklist when you receive your system to be certain you have received all your system

components. Also, please be sure to identify and remove all packing materials and

supports (foam pads, etc.) prior to initial turn on of the equipment.

All Single PA TX systems ship with an AC power cord included with the Exciter

and PA. The PA shipment also includes an RS232 cable, for Exciter to PA

communications, and a CAT5 Ethernet cable, for Exciter to PC built-in web interface

Remote Monitoring and Control.

ACT-PAVIII1-QSG-DOC-V1.1, 06/26/2018

ATSC VHF 100W Quick Start Guide

Page 7 of 17