Anywave PA-U2D-C-FA Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemancar Anywave PA-U2D-C-FA. Anywave PA-U2D-C-FA 20 halaman.

including IP, Mask, and Gateway. The AGC screen is used to turn the PA AGC On/Off and to change the

target AGC output power level.

Network Screen: The User can check and set all the Controller network information in this screen.



Re-Default: Reset Default settings - This button is used to set all the network settings to the

default values, as shown below:

IP:

MASK:

GateWay:



Set: There is a Set button for each bar on this screen. Pressing the Set button will lead to the

corresponding configuration screen of IP or Mask or GateWay accordingly. Using the IP setting

as an example, Press any part of the white bar on the IP Setting Screen and the keyboard (shown

below) will be enabled, turning from grey to yellow. The user can only set 3-digits of one bar at a

time. When the configuration is finished, press OK to confirm. If the keyboard is enabled by

ACT-PA-U2D-USR-DOC-V2.2, 09/25/2019

192.168.1.210

255.255.255.0

192.168.1.1

PA-U2D-C-FA User Manual

Page 17 of 20