Duerkopp Adler 251-140040 Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Mesin Jahit Duerkopp Adler 251-140040. Duerkopp Adler 251-140040 18 halaman.

1.Don't put your hand under the needle when you turn "on" the power switch or operate

the machine.

2.Don't put your hand into the thread take-up cover while the machine is running.

3.Turn

OFF

and the V belt.

4.Never bring your fingers, hair or clothing close to, or place anything on the handwheel,

V-belt, bobbin winder wheel or motor during operation.

5.If your machine is provided with a belt cover, finger guard and safety plate, never

operate your machine with any of them removed.

6.The hook rotates at a high speed while the machine is in operation. To prevent possible

injury to hands, be sure to keep your hands away from the vicinity of the hook during

operation. In addition, be sure to turn

the bobbin.

7.When tilting the machine head, exercise care not to allow your fingers etc. to be caught

under the machine head.

8.Do not wipe the surface of the machine head with lacquer thinner.

9.Never operate the machine unless its oil pan has been filled with oil.

10.Don't use a motor pulley of a larger outside diameter than the standard outside diameter

for the first onemonth.

11. Confirm that the voltage and phase (single- or 3-phase) are correct by checking them

against the ratings shown on the motor nameplate.

12,In case of maintenance, inspection, or repair, be sure to turn

and confirm that the sewing machine and the motor have completely stopped before

starting the work. (In case of the clutch motor, it continues rotating for a while by the

inertia even after turning

WARNING:

To avoid malfunction and damage of the machine, confirm the following.

Clean the sewing machine thoroughly before using it for the first time.

Remove all dust collected on the sewing machine during the transportation.

Confirm that the voltage and phase are correct.

Confirm that the power plug is properly connected.

Never use the sewing machine in the state where the voltage type is different from the

designated one.

The direction of rotation of the sewing machine is counterclockwise as observed from

the handwheel side. Be careful not to rotate it in reverse direction.

FOR SAFE OPERATION

the power switch before tilting the machine head or removing the belt cover

OFF

the power switch. So, be careful.)

OFF

the power to the machine when replacing

OFF

the power switch