ANZ POS MOBILE2 Panduan Referensi Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Terminal Pembayaran ANZ POS MOBILE2. ANZ POS MOBILE2 4 halaman.
Halaman CetakCHARGING THE TERMINAL BATTERY
•
Place the base on a clear, flat surface near the
mains power outlet.
•
Place the terminal on the base by securely
connecting the terminal to the docking connector
on the base
•
Connect the base power supply to the base
socket as shown below
Example of connecting base power supply to the
base socket
•
Connect the other end of base power supply to
the main power outlet on the wall
•
Check that the plug symbol
upper right hand side of the terminal screen indicating
that the terminal is connected into the power outlet
•
Check that the battery symbol
on the terminal screen indicating that charging is
in progress.
HOW TO LOAD PRINTER PAPER
A red line will appear on the paper, indicating that
the paper roll must be replaced. To re-load a new roll:
•
Open the paper compartment by lifting the
catch located at the rear of the terminal and
pull the cover to the rear of the terminal
•
Insert the paper roll (diameter 40mm) in the
compartment
•
Pull the paper up to the top of the terminal and
hold in position
•
Maintain the paper roll position and close the lid
•
Press the top of the lid in the centre until it clips
into position
Note: do not tamper with or remove the terminal housing
is displayed on the
is flashing or moving
CONFIGURING COMMUNICATION MODE
If you require your terminal to change communication
modes between 3G, WIFI, IP or Dial-Up, please follow
the steps below.
<Func>
1. Press
9, 9, 0, 5 and then press
2. At "Swipe Merchant Card" Press
<ENTER>
3. Press
to go to" COMMS MODE" Screen
4. Press 1 to select Dial-up communication mode Press
6 to select GPRS communication mode Press 7 to
select IP communication mode
<ENTER>
5. Press
until the ANZ main screen appears
How to Connect to WIFI Network:
Note: To connect to WIFI, ensure the Primary Comms Mode on the
terminal is set to 7 – IP
1. Press the right arrow key on the terminal
2. At Utility Function, type in 82077
3. Select Networks
4. Select New Network to scan for available networks
5. Select Automatic Scan
6. Select your desired network
7. Enter the WIFI password by using the letters and
numbers on the keypad and press ENTER
Note: For special characters, press '0' repeatedly until you see the
desired character
8. The terminal will now display WIFI Network
Connected
9. On the top left corner of the screen the WIFI
Network will display.
6. Press
<Func>
2, 4, 6, 8 <ENTER><ENTER>. "TMS
Logon Successful" should display on the terminal.
<Func>
8, 7 <ENTER><ENTER>. "ANZ
7. Press
Initialisation Approved" should display on the
terminal.
<ENTER>
<ENTER>