Duerkopp Adler 745-24 Petunjuk Pemasangan & Daftar Suku Cadang Pengganti - Halaman 5
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Daftar Suku Cadang Pengganti untuk Mesin Jahit Duerkopp Adler 745-24. Duerkopp Adler 745-24 14 halaman.
Halaman Cetak
2.4 Checking the V-belt Tension
2.5 Filling Oil
After transport check the V-belt tension set at the factory.
With correct tension the V-belts 5 (from the sewing drive to the
intermediate gear) and 1 (from the intermediate gear to the machine
head) can still be pressed in approx. 10 mm at the center with finger
pressure.
1
2
Tensioning V-belt 5:
–
Remove the belt guard after loosening the mounting screws.
–
Loosen screw 2.
–
Swing the sewing drive until the desired V-belt tension is achieved.
–
Tighten screw 2.
Tensioning V-belt 1:
–
Loosen clamping screw 4.
–
Press the belt tensioner 3 onto V-belt 1 until the correct V-belt
tension is achieved.
–
In this position tighten clamping screw 4.
–
Replace the belt guard again.
Use only ESSO SP-NK 10 lubricating oil for filling the oil reservoir.
SP-NK 10 is available from the DÜRKOPP ADLER AG sales offices.
–
Fill the oil reservoir for the hook lubrication and the reservoir for
the lubrication of the machine head up to the "Max" mark with oil
(see Chapter 3.2 of the Operating Instructions).
3
4
5
5