Dancing Wings Hobby 1.8M 1:5 Savage Bobber Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan Dancing Wings Hobby 1.8M 1:5 Savage Bobber. Dancing Wings Hobby 1.8M 1:5 Savage Bobber 8 halaman. Balsawood scale airplane

Halaman Cetak

03-15

SCG33-G.1

SCG33-G.2

SCG33-G.1

SCG33-G.2

方向舵,升降舵舵机及连杆安装

Install rudder and elevator steering gear and connecting rod

04-1

04-2

舵机线导入

Servo line import

04-4

舵角

Rudder horn

螺丝M3*20mm+自锁螺母

Screw +Self-locking nut

螺母

SCG33-E

自锁螺母

如左图在机身内放置线管，此线管为三段短管拼

接而成。穿入预留的孔位用CA胶粘固连接处。

Place a conduit inside the fuselage as shown

in the figure on the left, the conduit is spliced

by three short tubes.

Pass through the reserved hole and fix the

joints with CA glue.

在机身尾部预留位置安装2个

04-3

舵机，如左图所示，舵机线

导入线管，从另一端导出。

Install 2 servos in the

reserved position at the

舵机线导出孔

rear of the fuselage as

Servo line export hole

shown in the left figure,

the steering servo wire is

introduced into the wire

tube and exported from

the other end.

04-5

舵角

Rudder horn

此处连杆根据选用不同的舵机可

能需要弯曲。

Here the connecting rod may

need to be bent according to

the choice of different servos.

1.在舵机上安装舵臂，舵臂上安装快装接头。

Install the servo arm on the servo, and install the EZ-connector on the servo arm

2.连杆夹头一端夹住舵角，另一端穿入舵臂上的快装接头，调整到合适位置后，锁紧快装接头上的螺丝

One end of the connecting rod collet clamps the rudder horn, and the other end is inserted into the

EZ-connector on the rudder arm.

After adjusting to the proper position, lock the screws on the EZ-connector.

安装马达及头罩

Install the Motor and Cowling

05-1

05-3

05-6

夹头安装方法

见步骤03-9

Collet installation

method Refer to

M1.5

the step 03-9

自攻螺丝

Self-tapping screw

M3x10mm

05-2

05-4

05-5

自攻螺丝

马达座装入机头部，结合头罩的安装位置调整马达座伸出的长度，调整到马达，桨叶与

Self-tapping screw

头罩互不干涉，最后用自攻螺丝固定马达座。

Install the motor mount into the head of the aircraft, adjust the length of the

M3x10mm

motor mount according to the installation position of the cowling, so that the

motor, propller and cowling do not interfere with each other,and finally fix the

motor mount with self-tapping screws.

05-7

SCG33-C

自攻螺丝

Self-tapping screw

M3x8mm