Dancing Wings Hobby Savage Bobber Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pesawat terbang Dancing Wings Hobby Savage Bobber. Dancing Wings Hobby Savage Bobber 8 halaman. Balsawood scale airplane arf

Halaman Cetak

Install the rudder steering gear and connecting rod

04-1

Q2 Wooden rod

04-2

04-3

Assemble the rudder

arm as shown

Install the servo in the servo

position and fix it with screws.

M3*18mm+Self-locking nut

04-5

Alu. buckle

wire penetration

M3*15mm+Self-locking nut

The other end of the steel wire is connected to the servo arm

of the rudder as shown in the figure.

Two steel wire connecting rods are installed in an X-shaped

cross.

Install the servo seat at the

corresponding position in

the picture, fix the reverse

Epoxy glue

side with wooden rod and

black tie, and fix it with a

large amount of epoxy

resin adhesive.

Black

cable ties

Epoxy glue

Q2 Wooden rod

wire penetration

Install the servo arm on the servo and fix it with screws.

And install the steel wire stay wire.Here are 2 steel wires

controlling the steering rudder.

The two steel wire connecting rods are installed in the same

way, and the wires are kept tight after installation.

Install the elevator steering gear and connecting rod

05-1

05-2

Alu. buckle

Lead in servo wire

Install the servo in the servo hole of the horizontal tail and install

the servo arm. The servo wire is led into the conduit placed in the

previous step and led out from the other end. The left and right are

the same.

05-4

Connect the connecting rod to the servo arm, and tighten the

screws to fix it.

Place a conduit inside the fuselage as shown

in the figure on the left, the conduit is spliced

by three short tubes. Fix it on the fuselage

frame with a tie.

Black cable ties

05-3

Install the connecting rod on the servo arm and rotate the

connecting rod to adjust to the proper length

05-5

The left and right servo control groups are installed in the same

way.