Duevi PEPEROSSO Panduan Instalasi dan Penggunaan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Penggunaan untuk Sistem Keamanan Duevi PEPEROSSO. Duevi PEPEROSSO 19 halaman. Dissuader with nebulization irritating gas

Halaman Cetak

Plug in the CN1 connector already cabled

From control panel provide the unlock command on IN1 (remove the positive 12 V)

Press K1 button until the plunger back to its initial position

10.

Block Peperosso using IN1 (provide a positive 12 V)

11.

Remove jumpers JP1 e JP2 (in this way both tamper of Peperosso are activated)

12.

At this point make a functioning test using the test spray can (containing water, see "Test"

paragraph)

At the end of test block Peperosso using IN1 (provide a positive 12 V)

13.

Peperosso must stay at rest with the plunger completely back and settled

Only in this position is possible to fix the spray cans with the straps (fig. 6)

In this phase, to avoid unwanted nebulisations, (caused by error on wiring or moved on CN1),

remove the CN2 motor connector, in this way the plunger is mechanically blocked allowing a secure

installation

14.

Close the cover

15.

Plug in the CN2 motor connector

16.

Peperosso is ready to be used