Dancover 5.4m Series Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Tenda Dancover 5.4m Series. Dancover 5.4m Series 6 halaman. Garage tent
Juga untuk Dancover 5.4m Series: Manual (7 halaman)

Halaman Cetak

On each end of (no.1), install the Leg ( no.3). Repeat step 1 for all frames.

At this point stand up the front or back frame and add 7 male connecting pipes ( no.8 ).

Then stand up another frame and add 7 female connecting pipes ( no.2 ). For the remaining

frames use the male connecting pipes ( no.8 ).

Add the diagonals (no.9) to the rst and last legs (no.3 ).

Note : Make sure all screws are tight. Do not over-tighten.

ROOF ASSEMBLY

Take the roof and place it over the structure. Make sure that

the windows are on the two sides of the shelter, at front or at

back as your choice. Make sure ties are inside.

Tie all the ties around the pipes. Take the straps and pass

them underneath the pipes, pull up and tighten through metal

buckle.

SHELTER REINFORCEMENT

Before you install the oor brackets, make sure the distance

between the legs is 18 feet wide.

Place the oor brackets (14) at each end of the shelter. Then

drive in nails (15) into ground, gravel or asphalt. Other

material surfaces require other types of anchoring (cement

blocks, sand bags, screws and bolts, etc). Permanent anchors

are not provided with this unit.

DOOR INSTALLATION

Install doors at each end. Use elastics (13) to attach the door

to the roof with hooks (11). Close the end of hook on to the

elastic so it won't fall on out. Use the rail hooks to attach

door the door rails. When closing at the front, make sure all

elastics are attached on the inside and outside of the shelters.