Cascade 37310 MAGPlus Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Kebugaran Cascade 37310 MAGPlus. Cascade 37310 MAGPlus 4 halaman.
Halaman Cetak3. Next rotate the roller adjustment knob and associated lock ring counterclockwise so that the roller
assembly allows room for the rear tire to mount.
4. Lift the bicycle into position so that the rear QR skewer is aligned with the right and left axle clamp cones.
See Figure 3(currently labeled Figure 2).
4a. By turning both the adjustment knob and the release clamp clockwise, tighten the clamp cones until they
come into contact with the bicycle's QR skewer ends.
4b. Tighten the adjustment knob and release clamp until the bike is securely held in place and the bicycle's
rear wheel is centered on the roller assembly.
clamp can be opened and closed firmly.
if the lever will not open or close, loosen the adjustment knob by rotating counterclockwise.
•
If the lever is too easy to open or close by hand, tighten the adjustment knob by rotating
•
clockwise.
4c. Rotate the locking rings clockwise until they are firm against the frame. Verify the bicycle is securely
mounted to the trainer.
5. Tighten the roller adjustment knob clockwise until the roller contacts the rear tire.
an additional 1½ to 2 full turns.
from slipping while in use.
Test tire friction by quickly moving the tire a 1/4 turn back and forth.
another 1/4 turn on roller adjustment knob if needed.
will accelerate tire wear.
If you notice the tire slipping regularly during use, tighten the roller adjustment
knob by an additional ¼ turn as necessary to reduce slipping.
Over-tightening will cause both tire and unit damage. Tighten only enough to avoid tire slippage. Use a smooth
tread tire at least 23mm in width and maintain the maximum recommended inflation pressure for your tire.
Once this is set properly tighten the lock ring to the frame.
6. Attach the handlebar-mounted resistance lever to the bike's handlebar with the provided clamp.
USING YOUR TRAINER
1. To minimize the noise from your trainer during your workout, set the trainer on a floor mat or small section
of carpet and use a rear tire with a smooth tread pattern.
2. This trainer has 5 levels of resistance, to change the resistance level, pull the handle bar mounted resistance
knob inward or push it outward to your desired level of resistance.
and level 5 is the hardest.
See Figure 6. Changing gears on your bike will also have an effect on your
exertion levels.
Figure 6
Figure 4.(but label this fgure 2)
Align the QR skewer with the notch in the clamp cone.
Now while holding the bike frame in place test that the release
The release clamp should close firmly by hand.
The roller needs to provide only enough pressure to prevent the rear tire
Allowing the tire to slip against the roller while riding
Then tighten the knob
Do not over-tighten the roller adjustment knob.
Level 1 is the easiest level of resistance,
Apply