Dancover Bermuda HE94000 Manual - Halaman 3
Jelajahi secara online atau unduh pdf Manual untuk Pemanas Teras Dancover Bermuda HE94000. Dancover Bermuda HE94000 6 halaman. Infrared
Halaman Cetak
Do not try to repair by yourself when it is broken (such as cord, plug etc),please contact the service agent .
If the appliance is located in bathroom, laundry areas and similar locations .Make sure the plug is not in the circumstance or
take the necessary protection measures to prevent electric leakage of the plug
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and where it cannot be tripped over.
Connect to properly grounded outlets only. To disconnect heater, turn controls to off, then remove plug from outlet.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are
used or stored.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
Always plug heaters directly into a wall outlet/receptacle. Try not use with an extension cord or relocatable power tap
(outlet/power strip). Even use, make sure the current carrying capacity and rated voltage correspond to the relative
regulation
Check if the voltage indicated on the nameplate of the appliance corresponds to the local mains voltage before you connect
the appliance.
The appliance is not located immediately below a wall socket‐outlet.
The casing and the front cover of the appliance become extremely hot during operation. Pay attention that, no combustible
material due to Wind or other environmental influences covers or obstructs the appliance, such as curtains, marquees, flags,
plastic foil etc. Do not touch the appliance. Caution! Risk of scald injury!
In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the appliance must be discontinued
and remove the mains plug immediately. Do not try to repair the appliance by your‐self. Please contact with the service agent
or a suitably qualified electrician for maintenance
Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off before cleaning.
Keep out of reach of children. In order to keep children from the dangers of electrical appliances, never leave them
unsupervised with the machine. Consequently, when selecting the location for your machine, do so in such a way that
children do not have access to the machine. Children being supervised not to play with the appliance.
The appliance must only be mounted by an authorized specialist, paying attention to the relevant regulations of the power
supply companies and the regional construction regulations.
SAVE THESE INSTRUCTIONS
OPERATION INSTRUCTION
For additional protection the installation of a residual current device (RCD) is advisable.
Remove all package material (including anti‐vibration object of the lamp) and check the appliance, supply cord and the plug
for signs of damage.
Pay attention to the mounting place and all mounting material (dowels, screws). Ensure they are suitable and stable enough
for mounting and lastingly holding of the appliance.
Before mounting, the minimum safe mounting distances and tilt angles shown in the figures must be strictly followed.
1.
The distance between the bottom edge of the appliance and the floor must be at least 1.8 M.
2.
There must be a distance of at least 0.2 M between the appliance and the ceilings, roofs or other covers.
3.
There must be a distance of at least 0.5 M at each side between the appliance and walls or the like. See figure 2.
4.
Recommended degree to mounting surface is 45°. See figure 3.
Pay attention that, the installation of the appliance must not add excessive wind load.
Fix the mounting bracket on the wall first. Ensure that the place to be installed is secure and firm. Or connect the appliance to
the stand.
The heaters are also widely used under parasol with the help of parasol brackets
Adjust the desired angle of radiation and fasten all screws. Check regularly the screws' connection. Mechanical bearing
pressure and oscillation due to wind or rain could lead to loose.
Plug in the power source. Then observe, whether during the first 10‐15 minutes the appliance works trouble‐free.