Dancutter DC SUPER FLEX Petunjuk Manual - Halaman 12

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pemotong Dancutter DC SUPER FLEX. Dancutter DC SUPER FLEX 20 halaman.

Halaman Cetak

1. Cutter

1. FW/BW: use the joystick to operate the cutter's forward/

back movement.

2. VIDEO OUT: outlet for showing the camera image on an

external screen.

3. VIDEO IN: outlet for an external camera, if necessary (turn

the camera knob to "2").

4. OVERLOAD FW/BW: the green LED should preferably flicker/

shine when the forward/back drive is operating. If the electric

motor is overloaded, the red LED will shine and an acoustic

alarm will sound for about 5 seconds. After this, the power

supply to the motor will be disconnected. The controls will

switch back on again after about 10 seconds.

5. REVERSE FW/BW: this function reverses the signal to the

"FW/BW" joystick. Use this function if you are using an exter-

nal camera sees in the opposite direction from the camera

on the cutter. Turn the knob to the "left" position for normal

operation. Turning the knob to the right makes the joystick

work in reverse.

6. CAMERA: use this switch to turn on the camera on the cut-

ter. (Pos. "2": external camera) (Pos. "1": camera on the cutter)

7. LIGHT: use this switch to turn on the camera light.

8. GRINDER: start the Cutter by turning the switch to pos. "1".

9. REVERSE TURN: this function reverses the signal to the

joystick "turn/raise arm". Use this function if you are using an

external camera which sees in the opposite direction from

the camera on the cutter. Turn the knob to the "left" position

for normal operation. Turning the knob to the right makes

the joystick work in reverse. The "arm: up/down" function is

unchanged regardless of the switch position.

10. OVERLOAD TURN: the green LED should preferably flicker/

shine while the rotation function is operating. If the electric

motor is overloaded, the red LED will shine and an acoustic

alarm will sound for about 5 seconds. After this, the power

supply to the motor will be disconnected. The controls will

switch back on again after about 10 seconds.

11. REGULATOR: use this knob to adjust the speed of the

cutter's rotation function. The function is not available on DC

MAXI FLEX.

12. TURN/RAISE ARM: moving the joystick right or left acti-

vates the cutter's rotation function to the right/left. Pulling the

joystick away from the screen raises the cutter arm. Pushing

the joystick towards the screen lowers the arm. The up/down

speed of the arm is preset at the factory.

13. CAMERA CLEAN: pressing the button activates the

camera cleaner. The button shines green when the function is

active. Press the button again to switch off the camera cleaner

(the light in the button will turn off).

14. EMERGENCY: activating the emergency-stop button will

disconnect all 24 V DC supplying the electric motor and the

magnetic valves for air. The only function retained is the power

supply for the cutter's camera so it is possible for the operator

to view the cutter as it is being withdrawn from a pipeline.

WiFi is built into the control unit to provide a wireless connec-

tion for a VR headset (optional accessory).