Addictive Desert Designs ADD-Lander Panduan Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil Addictive Desert Designs ADD-Lander. Addictive Desert Designs ADD-Lander 6 halaman. 2005-current toyota tacoma overland rack
Juga untuk Addictive Desert Designs ADD-Lander: Panduan Memulai Cepat (5 halaman)

Halaman Cetak

ADDICTIVE DESERT DESIGNS® ®

ADDICTIVE DESERT DESIGNS

Preparation:

• Disconnect the negative battery terminal. Park the vehicle on level ground and set the emergency brake.

• We recommend reading through the installation instructions in whole before performing the work.

• When button head bolts are being used, install the supplied washer on the nut side. Then, hold the bolt station-

ary and only turn the nut to tighten. Do not turn the bolt to tighten hardware assembly, unless otherwise noted.

• Estimated Installation Time: 2 Hours for Assembly/Installation

**This installation requires 2 people for best results**

**Labor Rates are based on a vehicle with no pre-existing damage. Wiring labor is based on a standard wiring procedure

with light switches installed in an easily accessible location. Custom light triggering or switch mounting location will

result in a greater labor charge.**

You will need the following tools:

- Ratchet

- 5/16" Allen Wrench/Socket

Included in Kit:

48 - Button Head Bolts

48 - Nylon Lock Nuts

12 - Flat Washers

- Chase Rack Cross Members

Addictive Desert Designs® | Page 1

Additional Time Required to Install any Accessories

- 7/32" Allen Wrench/Socket

- T30 Torx Socket

(3/8"-16 x 1")

(3/8"-16)

(1/2")

2005-Current Toyota Tacoma ADD-Lander™

Overland Rack Installation Instructions

- 9/16" Socket or Wrench

48 - Flat Washers

(3/8")

12 - Button Head Bolts

12 - Square Rack Mount Nuts

- Chase Rack Side Pieces

(1/2"-13 x 1")

(1/2"-13)