Abtus AVS-1200C/V2 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengontrol Abtus AVS-1200C/V2. Abtus AVS-1200C/V2 8 halaman. Multimedia controller

Halaman Cetak
User Operation Guide
PROGRAMMING MODE
1. “Programming” Mode:
1.1 “Com2” Tab (Control of Projector)
This allows user to configure the communication port 2 accordingly with respect to their buttons
communication protocol (command code of the projector) as well as the it’s parameter setting.
“Serial”
This allow configuration of Com2 communication parameter i.e.
Baud rate, Data Bit, Parity Bit and Stop
bit of the controlled Projector.
Setting can be easily done with its individual drop list.
Bard Rate: 1200 to 115200
Data Bit: 7 or 8
Parity Bit: None or Odd or Even
Stop Bit: one
PROGRAMMING MODE
“Layer”
When “enable” this allow second layout command to be configure accordingly
“Hex Code”
Command code entry for the relative button, only Hex Code is allows
“Transmitter”
Com 2 allows IR or Serial to be transmitted in the case if either one of the two is not available at
the Projector controlled. “Check” on the respective box accordingly
1.2 “Com3 Tab” (Control of ABtUS AV Switcher AVS-1200SV2 or any RS-232 controlled AV switcher)
This allows user to configure the communication port 2 accordingly with respect to their buttons
communication protocol (command code of the projector) as well as the it’s parameter setting.