Danfoss 40 Instruksi Kalibrasi - Halaman 7

Jelajahi secara online atau unduh pdf Instruksi Kalibrasi untuk Pengontrol Danfoss 40. Danfoss 40 8 halaman. Ultrasonic energy meter
Juga untuk Danfoss 40: Panduan Pengoperasian (16 halaman), Panduan Instalasi (16 halaman)

Halaman Cetak

User Guide

3. Turn off the test mode

4. Meter calibration/

adjustment mode

SonoMeter 40

The test mode can be turned off in one of the following ways:

- long press the button selects page „INF" on the meter's LCD  short presses the button selects

„tEST off" on the LCD  long press the button and the test mode is turn off, there is no sign „TEST"

on the screen (when the test mode is activated in accordance with section 1.1 of this instruction);

- by short-circuiting the contacts "SERVICE", (when the test mode is activated in accordance with

section 1.2 of this instruction);

- via the optical interface, using the software "SonoMeter 40 Configurator" and optical head that

complies with EN 62056-21 standard (when the test mode is activated in accordance with section

1.1 or 1.3 of this instruction);

NOTE: the meter switches to the operating mode by itself 12 hours after activation the test

mode.

Meter calibration/adjustment allows to adjust the meter measurement of volume single point

characteristics.

It can be done by using the software "SonoMeter 40 Configurator" and optical scan head in

accordance with EN 62056-21 standard.

1) The calibration/adjustment mode can be activated by removing protecting lid (2) of ADJ and

shortcutting the pins.

2) The correction parameter for volume can be entered in the SonoMeter 40 Configurator fields

"Err[%]". The correction parameter is confirmed by clicking "Calculate". "Write configuration" stores

the adjustments into the meter permanent memory. "Read configuration" is used to verify that the

changes are stored.

NOTE: With the removed ADJ protective cover. The Manufacturer warranty is void!!!

BC389148615526en-010101 | 7