Danfoss ThermoControl-3 Manual Pemasangan - Halaman 6

Jelajahi secara online atau unduh pdf Manual Pemasangan untuk Pengontrol Danfoss ThermoControl-3. Danfoss ThermoControl-3 16 halaman.

Halaman Cetak
Mounting Guide
6.

Installing the controller

The housing should be fastened to a firm dry surface. To
do this you will need to unscrew the cover.
Carefully release the cover from the housing. When
you do this, bear in mind that the (40-core and 5-core)
ribbon cables are connected to the PCB inside the housing.
Both of these cables can be disconnected from the PCB.
6
DEN - SMT / PL
ThermoControl – 3
Fig.: Positions of the (40-core and 5-core) ribbon cables on the PCB
VM.GU.A1.02
WARNING! Risk of injury from electrical current.
The housing cover is on the front and is fastened
to the housing by six Phillips screws. Use a suitable
screwdriver to loosen and remove the screws.
CAUTION!
While removing the screws, make sure the cover does
not slip.
NOTE!
The position of the 5-core ribbon cable is marked,
inserting the plug incorrectly causes the membrane
keys to malfunction. The 40-core cable is protected
against incorrect insertion.
Danfoss District Energy